Start; Add 30 Seconds; Express Cook; Stop/Clear - Magic Chef MCM770W/B Instruction Manual

The START control (START/+30SEC pad) begins
any function. If cooking is interrupted by touching
STOP/CLEAR or by opening the door, touching
START/+30SEC will resume the cycle.

Add 30 Seconds

The +30SEC control (START/+30SEC) automatically
starts the microwave oven at 100% power for 30
seconds, and adds 30 seconds of cook time with
each additional touch of the control.
Time may be added to any cooking cycle in 30 -
second increments by touching START/+30SEC
during cooking.

Express Cook

Each of the EXPRESS COOK controls (number pads
1-6) automatically starts the microwave oven at 100%
power for 1 minute, 2 minutes, 3 minutes, 4 minutes,
5 minutes or 6 minutes, depending on which pad is
touched.

Stop/Clear

The STOP/CLEAR control clears any incorrect
command, and pauses and/or cancels any program
during cooking. It will not erase the time of day.
A cooking program may be paused by touching
STOP/CLEAR once or by opening the door. The
cycle may be resumed by touching START/+30SEC.
A cooking program may be canceled by touching
STOP/CLEAR twice, or by opening the door and
then touching STOP/CLEAR.
The STOP/CLEAR control is also used to lock and
unlock the control panel. See "Control Lock" section.

Clock

This is a standard 12-hour clock (12:00-11:59). If
the clock is not set, "0:00" will remain in the display.
When the clock is set, the ":" will flash. During cooking,
the clock may be seen for 3 seconds by touching
CLOCK.
To Set:
The microwave oven must be in standby mode (no
functions operating).
1. Touch CLOCK control (number pad 0).
"00:00" will appear in the display, with the first "0"
flashing.
2. Enter current time, filling all four digits from left to
right. The first digit can be only "1" or "0."
3. Touch START/+30SEC.

Start

Tones are audible signals that indicate the following:
One tone
Valid entry (short tone)
1.
End of stage in multistage cooking
2.
Control lock activated or deactivated (long tone)
3.
Five tones
1. End of cycle
2. End of Kitchen Timer countdown
The Kitchen Timer can be set in minutes and seconds,
up to 99 minutes, 99 seconds, and counts down the
set time. The Kitchen Timer may not be used while
any other function is operating.
NOTE: The Kitchen Timer does not start or stop the
microwave oven.
To Set:
1. Touch KITCHEN TIMER control (number 9 pad).
"00:00" will appear in the display, with the first "0"
flashing.
2. Enter desired time in minutes and seconds, filling all
four digits from left to right. Example: 1-0-0-0 for 10
minutes, or 0-5-0-0 for 5 minutes.
3. Touch START/+30SEC.
When the set time ends, end-of-timer tones will sound,
and the display will return to the time of day.
4. Touch STOP/CLEAR at any time during the countdown
to cancel the Kitchen Timer.
The Control Lock shuts down the control panel pads
to avoid unintended use of the microwave oven.
To Lock/Unlock Control: The microwave oven must
be in standby mode. Touch and hold STOP/CLEAR
for 3 seconds until one long tone sounds and the
display clears to show an outline of the display area.
Repeat to unlock control, and return the display to
the time of day. If any pad is touched while the
control is locked, there will be no response from the
microwave oven.
8

Tones

Kitchen Timer

Control Lock