Setting The Delay Timer; Starting A Programme - LAVAMAT 52810 User Information

To switch off RINSE +:
1. Turn the programme knob to COTTONS/LINEN, EASY-CARES/EASY IRON
or DELICATES (at any temperature).
2. Hold down the buttons PRE-WASH and DELAY TIMER at the same time,
until RINSE + goes out on the programme progress display.
RINSE + is now permanently switched off.

Setting the delay timer

The DELAY TIMER button allows the start of a programme to be de-
layed.
1. Select programme.
2. Press DELAY TIMER button once, if the wash programme is to start after
6 hours. The display 6h lights up.
Press DELAY TIMER button twice, if the wash programme is to start af-
ter 3 hours. The display 3h lights up.
3
If you press the DELAY TIMER button again, the time delay is cancelled.
The display goes out.
3. To activate the time delay, press the START/PAUSE button.
Note: If a time delay of 6 hours is selected, the display 6h is lit. After
3 hours the display changes and 3h is lit. After a total of 6 hours the
wash programme then starts.

Starting a programme

1. Check that the water tap is open.
2. Press the START/PAUSE button. The programme is started or starts after
the time delay set has elapsed.
During the wash programme, the current programme step is displayed
on the programme progress display.
3
If the START/PAUSE button is pressed and the END indicator flashes 4
times, the door is not closed properly. Push the door firmly closed and
press the START/PAUSE button again.
14