Table of Contents
Advertisement
Quick Links
Upright Vacuum
PARTS
Handle
Power cord release hook
Power cord
Power cord lower hook
On/Off switch
Crevice tool
Hose
Power cord lower hook
Pedal
OPERATION
• To release the power cord, turn the release hook
through 180° and remove the cord from the holder.
• Adjust the Carpet/Hard Floor selector to the desired
setting for the floor surface. For carpets and rugs, select
the carpet setting. For hard floors, lino, tiled floors,
wooden floors, etc. use the hard floor setting. This
should be done when the vacuum cleaner is turned on
and in the upright position, ensuring the selector is
pushed fully to the left or right.
• When using the attachments supplied or when storing,
always ensure the vacuum cleaner is locked securely in
the upright position.
9236
Please read
carefully and
retain for
future reference.
Front cover latch
Carry handle
Full bag indicator
Hard floor/carpet switch
Bumper
• When operating the foot pedal, press
down with your foot and then pull the
handle back towards you. The front of
the vacuum will rise slightly and will
drop once you release your foot from
the raised pedal.
Instructions
Hard floor/carpet switch
Advertisement
Table of Contents
Related Manuals for Coopers 9236
Summary of Contents for Coopers 9236
- Page 1 Upright Vacuum Instructions 9236 PARTS Handle Please read carefully and Power cord release hook retain for future reference. Power cord Power cord lower hook Front cover latch On/Off switch Carry handle Crevice tool Full bag indicator Hose Hard floor/carpet switch...
-
Page 2: Troubleshooting
WARNING • Always keep all air vents clear and free from dust, lint, hairs, etc. • Only use the recommended attachments and dust bags. • When the filter becomes dirty, rinse it in warm water and allow to dry • Do NOT use on outdoor or wet surfaces. fully before re-fitting. - Page 3 Locking tab Insert the new bag into the bag stand, ensuring the grooves are Hole correctly aligned with the back of the bag and re-fit the bag stand onto the bracket. Replace the front cover, ensuring the latch is secure. Grooves Bag stand New bag...
- Page 4 Push the new belt onto the brush roll pulley. Take the belt through the floor brush section towards the motor shaft. Push the brush roll into the grooves at the sides and then push the belt onto the motor shaft. Re-attach the belt cover and replace the bottom plate by aligning it with the groove at the front end of the...
Need help?
Do you have a question about the 9236 and is the answer not in the manual?
Questions and answers