Coopers F435 Instructions For Use

Copper Crumb Vac
Please read and retain these instructions for future reference
Please read this instruction manual thoroughly before starting and ensure you are familiar with the
operation of your new battery powered Copper Crumb Vac.
For cleaning up small, dry particles and debris from hard and upholstered surfaces such as: countertops,
desks, tables, tile and wood floors, low to moderate pile carpeting, sofas, chairs, beds, blankets, leather
surfaces, car interiors, bags and suitcases.

Operation

Installing Batteries:

1. Open upper dome housing by rotating it counter-
clockwise Indicator line on edge of dome housing should
move from "CLOSE" to "OPEN" (See Fig. 1)
2. Install 2x 1.5V AA batteries following the indicated
polarity (see Fig. 2)
3. Replace upper dome housing.
4. Run the copper crumble over the crumbs to be
vacuumed.

Turning ON/OFF

1. Use thumb or finger to slide power switch located on the side of the
unit from "OFF" to "ON".

Emptying/Cleaning

1. Remove base cover by pressing tab labelled "PUSH" while tilting base
cover downward to separate it from upper housing (see Fig. 3).
2. Remove filter assembly by simply pulling it out of upper housing. It will
"snap" free to expose the motor turbine.
F435 Instructions for Use

Batteries:

Requires 2x 1.5V AA batteries (not included)
Motor voltage: 3.0V DC
Approximate run time: 2 hours (per battery pair)
Cleaning capacity: 2.5 tablespoons.
v001: 06/02/19