Advertisement
5
(Wired input)
Locate where you would like your input
will be located. Drill a 7/8" hole to mount
wired input connector as shown.
(Blue Tooth)
You will need to pair your devise with the blue tooth receiver. Turn on your devise and
search for the signal. Once your devise has found the blue tooth receiver it will ask for a
pairing code. That code is "0000". You will only need to do this once.
INSTALLATION COMPLETE
E-Z-GO
, E-Z-Go
TXT
, and E-Z-Go
®
®
®
and Club Car
DS
are registered trademarks of Ingersoll Rand, Inc. Yamaha
®
®
registered trademarks of Yamaha Golf-Car Company. Any reference to Club Car
word marks, and products are only for purposes of identifying golf carts with which this Madjax product is compatible. Madjax products
are aftermarket parts and are not original equipment parts. Madjax is not connected to, affiliated with, sponsored by, or endorsed by either
Textron Innovations, Inc., Ingersoll Rand, Inc., Yamaha Golf Cart Company, or any of their parent or subsidiary companies.
RXV
are registered trademarks of Textron Innovations, Inc. Club Car
®
®
You will make your connections as
follows:
The mini amp will have three wires
4
coming from the power pigtail. There
will be (1) black, (1) red and (1)
orange. Black is negative. Red is 12+
and the orange is the switch leg. You
need to run the red to your 12+ power
source, the black to your ground and
the orange to your switch (not the
key switch). Most cars will have full
battery pack voltage (36/48) at the
key switch and that will burn up your
amp. You need to install a switch to
turn the amp on and off.
Note: If you are using a blue tooth
receiver, you will tie the red wire from
the blue tooth in with the orange wire
as shown.
, Yamaha
Drive
, G-14
, G-16
®
®
®
®
, E-Z-Go
, or Yamaha
or their associated trademarks,
®
®
®
, Club Car
Precedent
,
®
®
®
, G-19
, and G-22
are
®
®
®
Advertisement
