Table of Contents
Advertisement
Case Open Warning [Enabled]
Enables or disables the chassis open status feature. Setting to Enabled, clears
the chassis open status. Refer to section "1.10.2 Internal connectors" for setting
details. Configuration options: [Disabled] [Enabled]
Boot Virus Detection [Enabled]
Allows you to choose the VIRUS Warning feature from IDE Hard Disk boot sector
protection. If this function is enabled and someone attempts to write data into this
area, BIOS will show a warning message on screen and alarm beep.
Quick Boot [Enabled]
Allows you to enable or disable the system quick boot feature. When Enabled, the
system skips certain tests while booting. Configuration options: [Disabled] [Enabled]
Boot Up Floppy Seek [Disabled]
Enables or disables the chassis open status feature. Setting to Enabled, clears the
chassis open status. Configuration options: [Disabled] [Enabled]
Bootup Num-Lock [On]
Allows you to select the power-on state for the NumLock.
Configuration options: [Off] [On]
Typematic Rate Setting [Disabled]
Allows you to set the keystroke rate. Enable this item to configure the Typematic
Rate (Chars/Sec) and the Typematic Delay (Msec).
Configuration options: [Disabled] [Enabled]
The items Typematic Rate (Chars/Sec) and Typematic Delay (Msec) become
user-configurable only when the item Typematic Rate Setting is enabled.
Typematic Rate (Chars/Sec) [6]
Allows you to select the rate at which a character repeats when you hold a key.
Configuration options: [6] [8] [10] [12] [15] [20] [24] [30]
Typematic Delay (Msec) [250]
Allows you to set the delay before keystrokes begin to repeat.
Configuration options: [250] [500] [750] [1000]
OS Select for DRAM > 64MB [Non-OS2]
Set this item to OS2 only when you are running on an OS/2 operating system with
an installed RAM of greater than 64 KB.Configuration options: [Non-OS2] [OS2]
2-32
Chapter 2: BIOS setup
Advertisement
Table of Contents
