Table of Contents
Advertisement
2.3.5
SATA 1/2/3/4
While entering Setup, the BIOS automatically detects the presence of Serial ATA
devices. There is a separate sub-menu for each SATA device. Select a device item
then press <Enter> to display the SATA device information.
Main
Extended IDE Drive
Access Mode
Capacity
Cylinder
Head
Landing Zone
Sector
F1:Help
↑↓ : Select Item
ESC: Exit
→← : Select Menu
The BIOS automatically detects the values opposite the dimmed items (Capacity,
Cylinder, Head, Precomp, Landing Zone and Sector). These values are not user-
configurable. These items show 0 if no SATA device is installed in the system.
Extended Drive [Auto]
Selects the type of fixed disk connected to the system.
Configuration options: [None] [Auto]
Access Mode [Auto]
Sets the sector addressing mode. Configuration options: [Large] [Auto]
Before attempting to configure a hard disk drive, make sure you have the correct
configuration information supplied by the drive manufacturer. Incorrect settings
may cause the system to fail to recognize the installed hard disk.
Capacity
Displays the auto-detected hard disk capacity. This item is not configurable.
Cylinder
Shows the number of the hard disk cylinders. This item is not configurable.
ASUS M2NBP-VM CSM
Phoenix-Award BIOS CMOS Setup Utility
SATA1
[Auto]
[Auto]
-/+: Change Value
Enter: Select Sub-menu
Item Specific Help
Slects the type of
fixed disk connected
0 MB
to the system.
0
0
0
0
Select Menu
F5: Setup Defaults
F10: Save and Exit
2-17
Advertisement
Table of Contents
