Red Sound FEDERATION BPM FX - PRO Owner's Manual page 26

Operation
To check the current trigger synchronisation setting, press either the 'PULL' or PUSH' button once. The main BPM
display and SYNCHRONISATION indicators will now show the current setting, as in the following example:
After 4 seconds the BPM display and SYNCHRONISATION indicators will revert to their normal operation.
To adjust the trigger synchronisation setting, again press one of the buttons marked 'PULL' or 'PUSH' and then,
during the 4 second display period, press either button again to change the setting. Each half beat measure has 12
interim settings which allow very fine adjustments to be made to the synchronisation.
PULL: To 'Pull' the MIDI clock backwards, press the left button (PULL) during the 4 second display period.
The display reading will change for each single press as follows:
After the '-11' setting, the synchronisation will be pulled back exactly ½ beat, as indicated by the following display:
Further adjustments can be made beyond the 'PULL ½ beat' point (display reads from '-13' down to '-23') until the
synchronisation is pulled back by one complete beat (maximum PULL adjustment). For this setting the display will
show the following:
½ BEAT ADJUSTMENTS:
PULL button for 1 second.
FEDERATION BPM FX
PULL
SYNCHRONISATION
LGH / BAR POS LGH / BAR
BPM
PULL OK PUSH PULL
LGH / BAR POS
Display alternates
BPM
PULL OK PUSH
LGH / BAR POS
Display alternates
BPM
PULL OK PUSH
You can adjust the PULL setting in ½ beat steps by pressing and
Example: Trigger point = 'Synchronised'
BPM
Flashing 'OK' indicator
OK PUSH
BPM
+/UP
PULL PUSH
BPM
-/DOWN
NUDGE
POS LGH / BAR
BPM BPM
OK PUSH PULL OK
LGH / BAR
between
BPM
PULL OK
LGH / BAR
between
BPM
PULL OK
24
POS
Etc. to '-11'
PUSH
POS
PUSH
POS
PUSH
holding down the