Fiat BLUE&ME 2014 Owner's Manual Supplement page 26

There is no voice training required for using voice
commands with this system.
To issue a voice command to the system, press the
steering wheel button and wait for the radio to
mute, then listen for "Say a command" and then a tone
indicating that voice recognition is active. Then, speak
the command in your natural voice at a moderate pace.
When the system recognizes the command, it will ac-
knowledge your command by speaking a response or
acting on your command.
Voice commands are organized according to three in-
creasing levels: 1st level, 2nd level and 3rd level.
When a valid* 1st level keyword is said, the system will
activate 2nd level keywords; when a valid 2nd level
keyword is said, the system will activate 3rd level
keywords.
BLUE&ME™ OWNER'S MANUAL SUPPLEMENT 25
If the user says a valid 1st level keyword, then the
submenu relevant to that command will remain active
until a keyword leading to another level is given, the
interaction is interrupted or the system times out because
no command has been given; the same rule applies for
the other lower levels (2nd and 3rd level).
NOTE: For the list of available keywords, refer to VOICE
COMMANDS (KEYWORDS) - SUMMARY.
* Valid means that the keyword said is included in the
BLUE&ME™ "dictionary" and can therefore be recog-
nized by the system for the concerned level.
To repeat the last system voice announcement, press the
steering wheel button and say "Repeat" or hold the
steering wheel down for longer than one second.