Installation; Water Supply Connection; Drain Hose Connection; Position The Appliance - Proaction PRSL96W Installation & User's Instructions

Installation

Water supply connection

Caution: 2 people are required to
unpack and handle the appliance, it is
recommended that gloves are worn.
Carefully remove all packaging materials
including the foam base, dispose of correctly.
Connect the cold water supply hose to a
threaded ¾" connector and make sure that it is
fastened tightly in place.
If the water pipes are new or have not been
used for an extended period of time, let the
water run to make sure that the water is clear.
This will prevent the water inlet to be blocked
and damage the appliance.
WARNING:
Please close the hydrant after using.

Drain hose connection

1. Make a hooked end at the end of drain hose
with the plastic U-bend fitting (provided). The
hooked end should be dropped into a
drainage standpipe between 40cm and
100cm from the floor level.
2. The free end of the hose must not be
immersed in water to avoid the flow back.
3. You may connect the water inlet hose onto
the kitchen sink tap. You must obtain a
correct adaptor to match the inlet hose
connector for a secure connection. However,
permanent plumbing is recommended.
4. If leakage is observed, immediately shut off
the water supply and check the hose
connections fully. Tighten connections if
necessary.

Position the appliance

1. The dishwasher must be installed on a solid
level surface.
2. Position the appliance in the desired location.
The back should rest against the wall behind
it, and the sides along the adjacent cabinets
or wall. The water supply and drain hoses
can be positioned either to the left or right
side to facilitate proper installation.
3. To level the dishwasher, adjust the 4 level
screws (feet) under the dishwasher.
5