Pushing And Transporting The Scooter - KYMCO Agility User Manual

PUSHING AND TRANSPORTING THE SCOOTER

1. Please carefully read the safety information in
section 3 related to transportation first.
2. Pushing the scooter:
In order to push the scooter, you must place the scooter
in "freewheel" mode, which disengages the drive
motor. The release lever is located at the bottom right-
hand side of the scooter under the seat.
WARNING!
When the lever is pushed up in freewheel mode:
• The scooter must be on a flat surface and stationary.
• Do not sit on the
scooter.
To push the scooter:
=Freewheel
Mode: (Motor is
disengaged.)
1. Power off the scooter
and remove the key.
2. Pull the lever upwards
as far as the stop (see
diagram).
3. Push the scooter to your desired location.
4. Push the lever downwards as far as the stop (see
diagram ).
=Driving Mode:(Motor is engaged.)
1. Always switch the scooter off to push it.
2. Do not push the scooter too fast. If a pre-set
speed is exceeded while you are pushing the scooter,
the drive motor will switch on automatically and brake
the scooter.
19