009403
Hold the trimmer with both hands pull the switch trigger
A or B and move it in front of your body.
009403
1
3
009404
As a basic operation, tilt the blades towards the
trimming direction and move it calmly and slowly at the
speed rate of 3 - 4 seconds per meter.
009405
To cut a hedge top evenly, it helps to tie a string at the
desired hedge height and to trim along it, using it as a
reference line.
1. Trimming
direction
2. Tilt the blades
3. Hedge surface
to be trimmed
2
1. String
1
009406
Attaching the chip receiver (accessory) on the tool when
trimming the hedge straight can avoid cut off leaves'
being thrown away.
009407
To cut a hedge side evenly, it helps to cut from the
bottom upwards.
009408
Trim boxwood or rhododendron from the base toward
the top for a nice appearance and good job.
Installing or removing chip receiver
(accessory)
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before installing or removing chip
receiver.
NOTE:
When replacing the chip receiver, always wear
•
gloves so that hands and face does not directly
contact the blade. Failure to do so may cause
personal injury.
Always be sure to remove the blade cover before
•
installing the chip receiver.
The chip receiver receives cut-off leaves and
•
alleviates collecting thrown-away leaves. This can
be installed on either side of the tool.
7