Table of Contents
Advertisement
The PalmRouter Elite can support up to two modem connections simulta-
neously. The two serial ports labeled "SERIAL 1" and "SERIAL 2" can func-
tion as dial-out connections. To do so:
1) Connect the phone line to the modem/ISDN TA.
2) Connect the power adapter to the modem/ISDN TA and keep the
power off until all hardware installation procedures are complete.
Connecting the PalmRouter Elite to Your Network Environment
Use standard twisted-pair Ethernet cables with RJ-45 connectors to con-
nect computers or other Ethernet devices to the RJ-45 ports of the PalmRouter
Elite.
You can connect computers to any one of eight RJ-45 ports on the rear
panel of the PalmRouter Elite. But if you intend to connect the PalmRouter
Elite to another hub, we advise that you keep port No.8 free because this is
the only port that can be used to uplink the PalmRouter Elite to another hub.
Uplinking can be done by setting the DIP Switch beside the port from
"straight" to "crossover" mode.
Plug the power adapter of the PalmRouter Elite into an AC power outlet,
then plug the power adapter output cable into the power connector on the rear
panel of the unit. The Power LED on the front panel should be lit immediate-
ly.
6
Advertisement
Table of Contents
