Table of Contents
Advertisement
EASY INSTALLATION
Hardware Installation
Before connecting the XRouter to your LAN please verify that your
cable or DSL service is active and operating correctly. If you are expe-
riencing difficulties with your cable or DSL service, please contact your
service provider before proceeding with this installation.
Connecting the XRouter to Your Modem
After verifying that your cable or DSL service is functioning properly,
connect your cable modem or DSL modem to the XRouter by following
the instructions below:
1.
If you have not already done so, disconnect the Ethernet cable
from the computer that is currently connected to the DSL or
cable modem.
2.
Plug the RJ-45 connector from this cable into the WAN (Wide
Area Network) port on the back panel of the XRouter. (See
Figure 1.1)
3.
Leave the other end of this Ethernet cable connected to the
DSL modem or cable modem.
Ethernet
Cable
LAN
WAN
Ethernet
Mac
Cable
PC
Figure 1.1 - Connecting the Xrouter
Reset
Ethernet
Cable
Cable or DSL modem
5
Advertisement
Table of Contents
