Table of Contents
Advertisement
2.
Plug one RJ-45 connector (of a standard twisted-pair Ethernet
cable) to the XRouter's No. 4 LAN port.
3.
Plug the other end of this Ethernet cable into an available port
on the network hub.
(NOTE: Multiple network hubs can be connected to the
XRouter's LAN ports No.1-3 if these hubs are equipped with
uplink ports. By daisy-chaining a series of hubs, you can
connect up to 252 users to the XRouter.)
LAN
Hub
PC
Figure 1.2 - Connect an Existing LAN
Connecting the Power Supply
To provide your XRouter with power:
1.
Plug the power adapter of the XRouter into an AC power
outlet.
2.
Plug the other end of the power adapter cable into the power
receptacle on the rear panel of the unit.
3.
The Power LED on the XRouter's front panel should be lit
immediately.
WAN
Reset
Ethernet Cables
Mac
Cable Or DSL Modem
7
Advertisement
Table of Contents
