Advertisement
Connection to NavNet 1, vx2, 3D, TZtouch & TZtouch2
The DFF1 is defaulted to work with NavNet 3D MFDs. If you are connecting the DFF1
to an original NavNet 1, vx2, TZtouch only, or TZtouch2 network, you need to change
the MODE switches as shown below.
If the DFF1 will be installed in a network comprised of a NavNet 3D MFD8, MFD12 or
MFDBB AND a TZtouch display in a mixed configuration, the DIP Switches must
remain in the default settings shown below.
Please confirm the dip switch selection for your type of NavNet display. To access the
dip switches, remove the rubber cap on the front of the DFF1 unit.
Default settings
for NavNet 3D
Default settings:
Alternate settings:
If you have more than one network sounder in the system, please contact Furuno Tech
Support for setup information.
APPENDIX 2
DFF1 MODE Switch Settings
This setting is used when connecting the DFF1 directly to a NavNet 3D
MFD or to a NavNet 3D network using the HUB101.
This setting is used when connecting the DFF1 to NavNet 1, vx2, TZtouch
or TZtouch2. This setting must also be used when connecting to a NavNet
3D network using an Ethernet Hub or Switch, other than the HUB101.
Alternate settings for NavNet 1,
6
vx2, TZtouch & TZtouch2
Advertisement
