Advertisement
Quick Links
Advertisement
Related Manuals for Navnet TZ 2 touch
Summary of Contents for Navnet TZ 2 touch
- Page 1 Installation Checklist...
- Page 2 NavNet TZtouch2 Installation Checklist NavNet TZtouch2 Network Installation Connect all TZtouch2 MFDs to the Ethernet Network. If a HUB101 is used, set the internal HUB DIP switches to OFF (HUB101 DIP switches are OFF by Default). TZtouch2 MFDs do not use power synchronization.
- Page 3 Power ON the Ethernet Hub/Switch, PSU, the NMEA2000 backbone and all the sensors, and then Power ON the TZtouch2 MFDs. Furuno recommends at least one TZtouch2 MFD be installed in a location that ensures the MFD can receive a GPS signal, thus providing GPS data to the network.
- Page 4 If the transducer is listed as being eligible for “Enhanced” RezBoost mode, please enable Enhanced mode in the Fish Finder Pop-Up menu. Select the preferred data/sensor sources for the network by pressing the “Data Source” button in the “Initial Setup” menu. ...
- Page 5 MODE switches. If the DFF1-UHD will be installed in a network that includes a NavNet 3D MFD (MFD8, MFD12 or MFDBB), the DIP Switches must be changed to the position shown below.
- Page 6 NavNet 1, vx2, TZtouch only, or TZtouch2 network, you need to change the MODE switches as shown below. If the DFF1 will be installed in a network comprised of a NavNet 3D MFD8, MFD12 or MFDBB AND a TZtouch display in a mixed configuration, the DIP Switches must remain in the default settings shown below.
- Page 7 Connection to NavNet 1, vx2, 3D, TZtouch & TZtouch2 The DFF3 is defaulted to work with NavNet 3D MFDs. If you are connecting the DFF3 to an original NavNet 1, vx2, TZtouch or TZtouch2 only network, you need to change the MODE switches as shown below.
- Page 8 APPENDIX 4 PSU012/PSU013 Jumper Location for TZtouch & TZtouch2 Installations When the PSU012 or PSU013 power supply unit is connected to a TZtouch or TZtouch2 MFD, attach the shorting jumper (supplied) to J7 on the PWR Board. (PSU012 = 03P9481) (PSU013: 03P9483)