Tanaka TIA-340 Owner's Manual
Hide thumbs Also See for TIA-340:

Advertisement

Model Numbers:
TIA-340
TIA-340
TIA-340
TIA-340
TIA-340
A A A A A UGER
UGER
UGER
UGER
UGER
PARKLANDS Trading Co P/L • 106 Belmore Rd • Riverwood, NSW 2210 • Ph: (02) 9584-7700 • Fx: (02) 9153-9122 • Eml: orders@parklands.net
Owner'
Owner'
Owner' s Man
Owner'
Owner'
Supplier To The Outdoor Power Equipment Industry
s Man
s Man
ual
ual
s Man ual
ual
s Man
ual
P/N 30063
Date 04-20-01

Advertisement

Table of Contents
loading

Summary of Contents for Tanaka TIA-340

  • Page 1 Owner’ Owner’ s Man s Man Owner’ s Man s Man ual Owner’ Owner’ s Man Model Numbers: P/N 30063 TIA-340 TIA-340 TIA-340 TIA-340 TIA-340 Date 04-20-01 A A A A A UGER UGER UGER UGER UGER Supplier To The Outdoor Power Equipment Industry...
  • Page 2: Before Using This Unit

    TIA-340 Owner’s Manual Before using this unit: • Read the operator’s manual carefully. • Check that the cutting equipment is correctly assembled and adjusted. • Start the unit and check the carburetor adjustment. See “Maintenance”. WARNING The engine exhaust from this product...
  • Page 3 TIA-340 Owner’s Manual 1. What is what ? Since this manual covers several models, there may be some difference between pictures and your unit. Use the instructions that apply to your unit.
  • Page 4: Warnings And Safety Instructions

    TIA-340 Owner’s Manual 2. Warnings and safety instructions WARNING! • Antivibration systems do not guarantee that Operator safety you will not sustain whitefinger disease or • Always wear a safety face shield or goggles. carpal tunnel syndrome. Therefore, continual • Always wear heavy, long pants, boots and and regular users should monitor closely the condition of their hands and fingers.
  • Page 5 Fuel • Always use branded 89 octane unleaded gasoline. • Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of 25-50:1 (Gasoline (A) : Oil (B)), only for the state of California at 50:1. • Never use multi-grade oil (10 W/30) or waste oil.
  • Page 6: Assembly Procedures

    TIA-340 Owner’s Manual 4. Assembly procedures Assembling (Fig. 1-1) Connect the bit to drive shaft (1) of the power head and fix it with the snap pins (2) after setting the fixing pins (3) and washers (2 pcs. each). Selection of a Suitable Bit Choose an auger bit according to material to be bored.
  • Page 7 TIA-340 Owner’s Manual Drilling (Fig. 2-5) WARNING! Do not touch the bit when running the engine to avoid unexpected accident. Be sure to turn off the ignition switch before touching it. 1. Hold the handle firmly with both hands so that you may not be swung by the unit.
  • Page 8: Maintenance

    When the engine is idling the bit must under no circumstances rotate. NOTE FOR THE US MARKET!! (Fig. 3-1C) We would like to inform that the power augers TIA-340 of the US model, which carry the following label on the unit are different from ones for other market in carburetor adjustment.
  • Page 9 TIA-340 Owner’s Manual Air filter (Fig. 3-2, 2B) The air filter must be cleaned from dust and dirt in order to avoid: • Carburetor malfunctions. • Starting problems. • Engine power reduction. • Unnecessary wear on the engine parts. • Abnormal fuel consumption.
  • Page 10 TIA-340 Owner’s Manual Transmission (Fig. 3-4) Check transmission or gear for grease level about every 50 hours of operation by removing the grease filler plug on the side of transmission. If no grease can be seen on the flanks of the gears, fill...
  • Page 11 TIA-340 Owner’s Manual Maintenance schedule Below you will find some general maintenance instructions. For further information please contact your service dealer. Daily maintenance • Clean the exterior of the unit. • Check that the drilling attachment is properly centered, sharp, and without cracks.
  • Page 12: Specifications

    TIA-340 Owner’s Manual 6. Specifications...
  • Page 13 Declaration of conformity D6claration de conformit6 Dichiarazione di conformita Konformitiitserkliirung Declaraci6n de conformidad Konformitetsdeklaration Tanaka Kogyo Co., Ltd., 3-4-29 Tsudanuma, Narashino, Chiba, Japan Nous,soussignds, Noi, Der unterzelchnete, Nosotros, TIA-340 Declare under our sole responsibility that the product, power auger model...

Table of Contents