Panasonic SC-HT540 Setup Manual page 2

1
Assembling the speakers
STEP
[HT540] Front speakers
[HT990]
Front and surround speakers
Preparation
≥ To prevent damage or scratches, lay down a soft cloth and perform assembly on it.
≥ For assembly, use a Phillips-head screwdriver.
≥ Make sure you have all the indicated components before starting assembly, setup, and connection.
≥ There is no difference between the right and left speakers and stands.
≥ For optional wall mount, refer to page 38, Operations Guide.
[Note]
≥ [HT990]
The front and surround speakers are different.
– Check the label on the rear of speaker before attaching the stand (➜ page 4).
– The stand with shorter cable is for the front speaker.
[HT540] 2 Front speakers
(with cover plate)
[HT990]
2 Front speakers and
2 Surround speakers
(with cover plate)
1
Attach the stand to the base.
1 Thread the speaker cable through the base.
For quicker threading, loosely fold the cable in half (do
not crease), pass the folded portion through the hole,
and then pull the rest of the cable through the base.
Cable
2 Attach the stand to the base while gently pulling
on the end of the speaker cable.
[HT540] 2 Stands (with cable)
[HT990]
4 Stands
≥ 2kstands with short cable:
For front speakers
≥ 2kstands with long cable:
For surround speakers
Base
Stand
Base
Cable
Pull gently.
The supplied stands are specially designed
for attachment to Panasonic SB-FS990 front
speakers, SB-FS741 surround speakers,
SB-FS540 front or surround speakers.
Use only as indicated in this setup.
[HT540] 2 Bases
[HT990]
2
Secure the stand to the base.
Screw
Tighten securely.
Stand
Base
1
Screws
Tighten securely.
3
Attach the speaker to the stand.
1 Pull out the end of the speaker cable and
position it between the ridges.
Ridges
Stand
2
[HT540] 8 Screws
[HT990]
4 Bases 16 Screws
2
Slide the speaker
cable into the
groove.
Cable