Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Mackie Fussion 1800S
Summary of Contents for Mackie Fussion 1800S
- Page 1 FUSSION 1800SA & 1800S ACTIVE SOUND REINFORCEMENT SUBWOOFER SYSTEM USER’S MANUAL...
-
Page 2: Safety Instructions
Mackie product. 10. Object and Liquid Entry — Care should be taken so that objects do not fall into and liquids are not spilled into this Mackie product. 11. Damage Requiring Service — This Mackie product should be serviced only by qualified service personnel when: 12. -
Page 3: Table Of Contents
... 5 Don’t forget to visit our website at for more information about this and other Mackie products. ©2000 Mackie Designs Inc. All Rights Reserved. Printed in Italy. Rev. B According to OSHA, any exposure in excess of these permissible limits could result in some hearing loss. -
Page 4: Introduction
The FUSSION 1800SA is specifically designed to work with the FUSSION 1800S. Power for the passive 1800S is provided by the 1800SA via a Neutrik™ female Speakon connector lo- cated on the rear panel. Because the amplifier is located just... -
Page 5: Rear Panel Description
This is a female Neutrik™ Speakon con- nector that produces a speaker-level signal between the frequencies of 35Hz to 85Hz. Connect this to the FUSSION 1800S pas- sive subwoofer. The signal at this connector comes from a 2000W amplifier identical to the one powering the FUSSION 1800SA. -
Page 6: Connections
LOOP OUT jack is exactly the same as the signal going in. The POWER OUT connector delivers a speaker-level signal to the FUSSION 1800S cabinet. Use 4-pin Neutrik™ Speakon con- nectors on heavy-gauge speaker wire. The... -
Page 7: Placement
You can stack cabinets vertically. If you do, place the FUSSION 1800SA and 1800S on the bottom of the stack, side by side, and place the full-range active Fussion Series cabinets on top. -
Page 8: Rigging
RIGGING The FUSSION 1800SA and 1800S cabi- nets are not designed for rigging or flying. The cabinets are for floor-mounting only. WARNING: Never attempt to suspend the FUSSION 1800SA or 1800S loudspeakers by their handles. AC POWER The FUSSION 1800SA is shipped with a connector that mates with the AC recep- tacle on the rear panel. -
Page 9: Service Information
Troubleshooting section. Doing so might save you from being deprived of your Mackie loudspeaker. Of all Mackie products returned for ser- vice (which is hardly any at all), many are coded “CND” — Could Not Duplicate— which usually means the problem lay some- where else in the system. -
Page 10: Repair
REPAIR Service for the FUSSION 1800SA and 1800S is available only from one of our authorized domestic service stations or at the factory service center, located in Whitinsville, Massachusetts. Service out- side the United States can be obtained through local dealers or distributors. -
Page 11: Fussion 1800Sa/1800S Specifications
“Mackie,” the “Running Man” figure, and “FUSSION” are trademarks or registered trade- marks of Mackie Designs Inc. All other brand names mentioned are trade- marks or registered trademarks of their respective holders, and are hereby acknowledged. - Page 12 ® ™ 16220 Wood-Red Rd. NE • Woodinville, WA 98072 • USA 800/898-3211 • Outside the US: 425/487-4333 ® Mackie Designs Inc. Mackie Designs Inc. Fax: 425/487-4337 • www.mackie.com E-mail: sales@mackie.com ®...