Mackie MR10Smk3 Owner's Manual
  1. Manuals
  2. Brands
  3. Mackie Manuals
  4. Subwoofer
  5. MR10SMK3
  6. Owner's manual

Mackie MR10Smk3 Owner's Manual

Powered studio subwoofer
Hide thumbs Also See for MR10Smk3:
Table of Contents

Advertisement

Quick Links

MR10Smk3
Powered Studio Subwoofer
O W N E R ' S M A N U A L

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MR10Smk3 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Mackie MR10Smk3

Summary of Contents for Mackie MR10Smk3

  • Page 1 MR10Smk3 Powered Studio Subwoofer O W N E R ’ S M A N U A L...

  • Page 2: Important Safety Instructions

    The exclamation point within an equilateral triangle is intended to alert the user of the prescence of important Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan. operating and maintaining (servicing) instructions in the literature accompanying the appliance. Apparatet må tilkoples jordet stikkontakt. MR10Smk3 Apparaten skall anslutas till jordat uttag.

  • Page 3: Table Of Contents

    APPENDIX B: CONNECTORS ............12 APPENDIX C: TECHNICAL INFORMATION ........13 MR10Smk3 SPECIFICATIONS ..........13 MR10Smk3 DIMENSIONS .............14 MR10Smk3 BLOCK DIAGRAM ..........14 MR10Smk3 LIMITED WARRANTY ..........15 Please write your serial number here for future reference (i.e., insurance claims, tech support, return authorization, make dad proud, etc.)

  • Page 4: Introduction

    MR10Smk3 Powered Studio Subwoofer your acoustics is necessary. is designed for high-output low end performance. Adding an MR10Smk3 studio subwoofer to your system The low-profile enclosure is rear-ported to provide only adds to the experience. It not only delivers the...

  • Page 5: Quick Start

    7. Turn on the power switch [3] on the MR10Smk3. • Save the shipping box! You may need it someday. 8. Slowly turn up the input level [9] control on the •...

  • Page 6: Rear Panel Description

    When the power switch and adjustments are made to the frequency response of is turned on and the MR10Smk3 studio subwoofer is the speakers to match the subwoofer’s location and the plugged into an AC outlet, the LED [6] illuminates to room’s environment.

  • Page 7: Signal Outputs

    This 3-position switch turns the amplifiers on or off, or sets them to automatic mode. Use this switch to set • MR5mk3 : 57 Hz the MR10Smk3 to your preferred mode of operation. • MR6mk3 : 46 Hz • MR8mk3 : 40 Hz •...

  • Page 8: Protection Circuits

    Excessive low-frequency energy stereo receiver to the inputs of the MR10Smk3 studio can damage the woofer by causing it to “bottom out,” subwoofer if the receiver doesn’t have preamp outputs also known as overexcursion, which is equivalent or other line-level output connections.

  • Page 9: The Ins And Outs Of Polarity

    This is normal, as our ears perceive them both at the same time. The polarity switch comes into play when the MR10Smk3 studio subwoofer is paired with a studio monitor. Ideally, the woofer cones of the subwoofer and monitor would work together by pushing and pulling in unison.

  • Page 10: Appendix A: Service Info

    Appendix A: Service Information If you think your MR10Smk3 Studio Subwoofer No Sound has a problem, please check out the following • Is the power LED [6] on the rear panel illuminated? troubleshooting tips and do your best to confirm If not, refer to “No Power”...

  • Page 11: Repair

    To locate the nearest service center, visit www.720trees.com, click “Contact Tech Support” and select “Locate a Service Center or Distributor” [3]. Service for an MR10Smk3 living outside the United States may be obtained through local dealers or distributors.

  • Page 12: Appendix B: Connectors

    Balanced 1/4" TRS Input Connector XLR connectors are used to make balanced “TRS” stands for Tip-Ring-Sleeve, the three connections connections to the MR10Smk3 studio subwoofers. They available on a stereo 1/4" or balanced phone jack or are wired as follows, according to standards specified plug.

  • Page 13: Appendix C: Technical Information

    Sound Pressure Level @ 1 meter, +4 dBu into Balanced Input: Japan: 100 VAC, 50/60 Hz 113 dB SPL @ 1m Note: MR10Smk3 subwoofers do not support multiple voltage Maximum SPL Per Pair: 119 dB SPL @ 1m configurations. Make sure the voltage rating for your particular model (as indicated on the rear panel near the IEC socket) corresponds with your local AC mains voltage.

  • Page 14: Mr10Smk3 Dimensions

    MR10Smk3 Dimensions 12.6" / 320 mm 15" / 381 mm WEIGHT 27.3 lb / 12.4 kg 15" / 381 mm MR10Smk3 Block Diagram +HI VDC LO-FREQUENCY OVEREXCURSION VARIABLE LP POLARITY DRIVER PROTECT [40 HZ – 180 HZ] INVERT INPUT LEVEL...

  • Page 15: Mr10Smk3 Limited Warranty

    Limited Warranty Please keep your sales receipt in a safe place. This Limited Product Warranty (“Product Warranty”) is provided by LOUD Technologies Inc. (“LOUD”) and is applicable to products purchased in the United States or Canada through a LOUD-authorized reseller or dealer. The Product Warranty will not extend to anyone other than the original purchaser of the product (hereinafter, “Customer,”...
  • Page 16 16220 Wood-Red Road NE Woodinville, WA 98072 • USA Phone: 425.487.4333 Toll-free: 800.898.3211 Fax: 425.487.4337 www.720trees.com...

Table of Contents