Advertisement
Weil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fired Burners
6
1. Figure 10, page 11, shows flue collector components
and locations. Figure 11, page 13, shows collector hoods
for all models. Follow all instructions in this manual to
ensure correct installation of the flue collector.
2. Model 80 boilers are available with either rear flue or
top flue. Verify that you have the correct components
for your application. You can convert a Model 80 from
rear to top or top to rear flue using a flue conversion
bolt assembly at each section joint, and on both sides
of the boiler section assembly. Set aside the flanged nuts
for securing the collector assembly when it is ready.
2. Each hold-down bolt assembly consists of a
carriage bolt, flat washer, regular hex nut and a flanged
nut as shown.
as in Figure 8, left side.
10
The flue outlet for top flue models must
be located as shown in this manual.
otherwise damaged. These conditions can
monoxide emissions, resulting in severe
personal injury or death.
The boiler contains ceramic fiber and
fiberglass materials. Use care when
handling these materials per instructions
on page 38 of this manual. Failure to
comply could result in severe personal
injury.
Collector hood preparation
bolt holes. Secure with seven
and flanged nuts.
right column.)
a. Stand remaining hood module on end, as in
Figure 8, right side.
e. Secure with seven
flanged nuts.
12.)
5
/
" x 2"
16
and oil.
rope around corners.
.
joints must be sealed gas-tight to prevent
monoxide emissions, resulting in severe
personal injury or death.
excess rope.
Double-faced tape serves only to hold
4
) on end
sealing rope in place during installation.
It will disintegrate over time. If collector
hood and sealing rope are removed for
any reason, install new tape and new
Flue collector sealing rope installation
) on flange.
5
5
/
" x
/
" flanged bolts
16
8
.
on page 12, top
5
5
/
" x
/
" flanged bolts and
16
8
.
Part No. 550-141-935/0215
Advertisement
