TURN SIGNAL/LIGHTS/HIGH BEAM LEVER
Turn Signal/Lane Change Assist
•
Tap the lever up or down once and the turn signal (right or left) will flash briefly to
indicate a lane change and automatically turn off.
Headlights/Parking Lights
•
The ignition switch must be in the ON/RUN position for the headlights to operate.
•
Rotate the end of the lever to the first detent for parking lights and headlight
operation.
High Beams
•
Push the lever forward to activate the high beams.
•
A high beam symbol will illuminate in the cluster to indicate the high beams are on.
NOTE:
For safe driving, turn off the high beams when oncoming traffic is present to prevent
headlight glare and as a courtesy to other motorists.
Flash To Pass
•
Pull the lever toward you to activate the high beams. The high beams will remain on
until the lever is released.
Headlight Delay (Follow Me Home)
•
Within two minutes from when the engine is turned off and the ignition key is in the
OFF/LOCK position or removed, pull the turn signal lever toward the steering wheel.
•
Each movement of the lever toward the steering wheel will increase the illumination
period by 30 seconds, up to a maximum of 210 seconds.
OPERATING YOUR VEHICLE
19