Table of Contents
Advertisement
Adjusting Projected Images
Setting Auto Iris
By automatically setting the luminance according to the brightness of the
displayed image, it lets you enjoy deep and rich images.
a
• Auto Iris can only be set when the Color Mode is set to Dynamic
(3D Dynamic) or Theatre (3D Theatre).
• When Edge Blending is set to On, Auto Iris is disabled.
a
Press the [Menu] button while projecting.
b
Select Auto Iris from Image, and then press the [
c
Select High Speed, and then press the [
If you are concerned about the operation noise of Auto Iris, set it to
Normal.
The setting is stored for each color mode.
d
Changing the Aspect Ratio of the Projected Image
You can change the Aspect Ratio
the ratio of height and width, and the resolution of the input signals.
Available aspect modes vary depending on the Screen Type currently set.
a
] button.
Changing methods
Each time you press the [Aspect] button on the remote control, the aspect
mode name is displayed on the screen and the aspect ratio changes.
Auto
] button.
Normal
4:3
16:9
Full
Press the [Menu] button to finish making settings.
g
of the projected image to suit the type,
Set the Screen Type before changing the aspect ratio.
s "Screen Settings"
p.27
Remote control
Aspect Mode
Projects in an appropriate aspect ratio based on
information from the signal being input.
Projects while retaining the aspect ratio of the input image.
Projects at an aspect ratio of 4:3.
Projects at an aspect ratio of 16:9.
Projects at the full size of the projected screen.
72
Explanation
Advertisement
Table of Contents
