Table of Contents
Advertisement
can be used to connect one composite video input. Video is input
into the V2403 by connecting an external video source (e.g., a
camera) to a BNC connector.
V2403-4 distributes each video input into 8 video outputs through
the four video output connectors labeled the same number as the
input connectors.
V2403-8 distributes each video input into 4 video outputs through
the four video output connectors labeled the same number as the
input connectors.
V2403-16 distributes each video input into two video outputs
through the two video output connectors labeled the same number
as the input connectors.
Please refer to the following table to select appropriate coaxial
video cables:
Table 2-1. Coaxial Cable & Maximum Operating Distance
Coaxial Cable Type
RG59/U
RG6/U
RG11/U
2.3.2 Video Output Connections
The V2403-4 amplifies a set of 4 video input signals and distributes
them to a total of 32 outputs.The V2403-8 amplifies a set of 8 video
input signals and distributes them to a total of 32 outputs. The
V2403-16 amplifies a set of 16 video input signals and distributes
them to a total of 32 outputs. 32 BNC connectors, labeled as
"VIDEO OUTPUT", are provided on the rear panel for connecting
video outputs (e.g., monitors).
To connect a monitor to its associated video output terminal:
1. Properly install the monitor according to relevant manuals.
2. Connect the necessary coaxial video cables to the desired BNC
output port located on the rear panel of the V2403.
3. Set the monitor's termination to 75 ohm.
Note: If the video is being looped through a monitor, the
termination must be set at High Resistance (HiZ).
2.3.3 Power Connection
The V2403 series Video Distribution Amplifiers are designed for a
100~240V AC power source.
Warning: Do not power on the device when connecting wires.
Note: When powering the V2403, check that the power source
specifications correspond to those required. The use of improper
components or equipment will seriously compromise the safety of
the personnel and the installation.
2
Max. Transmission Distance
750 ft (229 m)
1000 ft (305 m)
1500 ft (475m)
Appendix I Specifications
Video
Video Input:
1.0 V
Video Output:
1.0 V
Max. Video Inputs:
8 or 16
Max. Video Outputs: 4 sets of 8, or 2 sets of 16
Amplitude Frequency: ±1.0 dB 5.8MHz
Bandwidth:
5Hz~7.5MHz
Electrical
Input Voltage:
100~240V AC
Power Consumption: 6W
Mechanical
Dimension:
1.7"(H) × 19"(W) × 10.2"(D)
44mm (H) × 483mm (W) × 260mm (D)
Weight:
3.4lb (1.55kg)
Mounting:
Optional rack or desktop mounting
Environmental
o
Temperature:
0
C~50
Humidity:
0~90%RH (non-condensing)
composite signal, 75ohm BNC
P-P
composite signal, 75ohm BNC
P-P
o
o
o
C (32
F~122
F)
Advertisement
Table of Contents
