Gobosource ECO Spot 70-C User Manual

ECO Spot™ 70-C User Manual
Thank you for choosing an ECO Spot™ Gobo projector. This unit is
equipped with a Gobo Changer and a fan cooled 70 HID light bulb
with a rated bulb life of 9,000 – 12,000 hours..
Please read this manual before installing or operating this fixture,
follow the safety precautions listed below and observe all warnings.

Package Contents


Projector with power cord

Test Gobo

Spare gobo retaining ring

Spare drive belt

LED Light Bulb

Safety Information

Before the initial start-up, please unpack and carefully check for damage caused

during transportation.
ONLY OPERATE THE FIXTURE FULLY ASSEMBLED

Place your fixture at a suitable place with good air flow.

Make sure there are no flammable materials close to the lamp.

Do not look directly into the lamp, it may result in eye damage.

This fixture should be installed and operated only by qualified personnel.

Always disconnect the unit from power and allow cooling down before servicing.

Always ground (earth) the fixture electrically.

Use only a power source that complies with local building and electrical codes and

has both, overload and ground-fault protection.
Do not use the fixture if the power cable or power plug is in any way damaged,

defective or wet, or if they show signs of overheating.
When suspending the fixture above ground level, verify that the structure can hold

at least 10 times the weight of all installed devices.
Verify that all external covers and rigging hardware are securely fastened and use

approved means of secondary attachment such as a safety cable.
Warranty
One Year from Date of Purchase
Contact
Globus New Media LLC
Tel 1-888-987-1112 or 1-408-416-4444
Copyright © 2012 Globus New Media LLC
ECO Spot 70-C User Manual
Page 1