Subscribe to Our Youtube Channel
Related Manuals for Naxa NRC-180
Summary of Contents for Naxa NRC-180
- Page 1 Easy-Read Dual Alarm Clock Radio with USB Charge Port NRC-180 Instruction Manual Please read carefully before use and keep for future reference.
-
Page 2: Important Safety Information
10. Protect the power cord from being walked on or pinched to the State of California to cause cancer and birth defects particularly at plugs, convenience receptacles, and the or other reproductive harm. Wash hands after handling. point where they exit from the apparatus. Page 2 Naxa Electronics... - Page 3 Any changes or modifications not expressly approved by the may cause undesired operation. grantee of this device may void the authority granted by the Note: This equipment has been tested and found to comply FCC to operate the equipment. www.naxa.com Page 3...
- Page 4 FM: Press and hold to save a to set Alarm 2. preset station. BT: Press to start/pause/re- sume playback. BT: Press and hold to place the system in Pairing mode. Standby (Off): Press and hold to set the clock time. Page 4 Naxa Electronics...
- Page 5 FM: Press and hold to scan for the next station on a higher frequency. (To cancel scan- ning, press again.) BT: Press to skip to the next track. When setting the clock or an alarm, press to set the minutes. www.naxa.com Page 5...
- Page 6 Off: The Alarm 1 timer is alarm timers, FM radio fre- inactive. quency, and more. 10 AL2 LED On: The Alarm 2 timer is active. Off: The Alarm 2 timer is inactive. Page 6 Naxa Electronics...
- Page 7 Convenient charge port provides power for your smartphone or other USB device. Power input (DC Connect to a power source with the included power adapter. 3.5mm AUX input 3.5mm stereo connection for devices with 3.5mm line-out or headphone output. www.naxa.com Page 7...
-
Page 8: Battery Backup
AC power. when setting the clock. Insert two UM-4 batteries (AAA) into the battery compartment. Be sure to observe the proper po- larity (the “+” and “-” signs) as indicated inside the battery compartment. Page 8 Naxa Electronics... -
Page 9: Setting The Alarms
MER button once. the time cycles back around. The alarm will then sound again automatically When the correct alarm time is set, press the after 9 minutes. VOL+/AL1 -SET button to confirm (or VOL−/ AL2-SET for Alarm 2). www.naxa.com Page 9... -
Page 10: Listening To The Radio
MEM/ button to save the current frequency as Preset 01. To tune to a preset station: Press the /TIME SET button; the display screen will flash with the current preset station number (e.g., “P02”). Page 10 Naxa Electronics... - Page 11 The options are 90-80-70-60-50-40-30-20- While the Bluetooth LED is flashing: 10-min. or OFF. Make sure Bluetooth is enabled on your de- The radio will turn off automatically after the ® vice. Enable it if it hasn’t. set time has elapsed. www.naxa.com Page 11...
- Page 12 The speaker will announce itself as the “NAXA NRC-180.” Select it from the list of devices. To do this..do this If your device asks for a passcode, use “0000”...
-
Page 13: Using Aux Input
Press VOL–/AL1-SET to gradually increase the the manufacturer’s specifications. volume of the speaker to a comfortable level. There are many different devices with different power requirements; www.naxa.com Page 13... -
Page 14: Specifications
Input Bluetooth v2.1+EDR 3.5mm AUX audio USB Charge Port Yes (DC 5V, 1A) Power Source AC 100-240V adapter 2 x AAA batteries (clock backup, not included) Specifications are subject to change without prior notice. Page 14 Naxa Electronics... - Page 15 If you have problems with your device, please con- sult the instructions in this manual. Please also vis- it us on the web at www.naxa.com to get up to the minute news, alerts, and documentation for your device. For additional assistance, please contact Naxa Technical Support.
Need help?
Do you have a question about the NRC-180 and is the answer not in the manual?
Questions and answers