Asante 8001/P/W User Manual page 23

Streaming: Video Streaming Protocol
a.
b.
c.
Brightness/Contrast:
Brightness: 0-100 adjustable
Contrast: 0-100 adjustable
Alert " Alert light will flash in "RED" if the alert trigger condition is met. Please refer to "Event" menu
about trigger condition. This is to raise attention to staff who is monitoring the camera.
Press button again will reset the alert.
REC: "Record the video. By default, it will be stored at C:\video. You may change it at PATH
button.
SNAP shot: Real-time image capture will be stored at C:\snapshot as default. You may change it
at PATH button.
PATH: Change record or snap shot storage path at your local PC.
Audio On/Off: Enable or Disable device audio input
Microphone: Enable or Disable monitor side audio input – from PC/laptop microphone input.
©2007 Asante Networks Inc., All rights reserved. NetCam are registered trademarks of Asante Network, Inc.
All other names may be trademarks or registered trademarks of their respective owners. Specifications subject to change without prior notice.
UDP (User Datagram Protocol)
UDP is non-flow control protocol and it is good for real time video voice
application. However, the UDP packet will no guarantee of delivering and
re-transmit if UDP packet loss due to the network or intermediate IP
network node congestion or service disruption.
TCP (Transmission Control Protocol)
Unlike UDP, it has flow control it will guarantee of delivering by giving
buffering and retransmit mechanism. This device using RTSP (Real-time
Transport Streaming Protocol) to streaming the video/audio and it is a
TCP application.
HTTP (Hypertext Transfer Protocol)
HTTP is WWW application protocol using TCP port 80. This is very open
to most enterprise and home router/firewall system. Leverage HTTP for
video streaming would be easier for most environments but would potential
receive more intrusion.
23