Table of Contents
Advertisement
Note:
The illustrations in this manual are for explanation purposes only and may differ from the
actual unit. It is subjected to change without notice for future improvement.
PRODUCT OVERVIEW
Indoor Unit
Discharge Vent
Horizontal airflow
vanes
Vertical airflow
vanes
Air filter
Intake grille
Air intake
Outdoor Unit
Air inlet
Troubleshooting
Operation delayed for few minutes after restart.
l
Sound like water flowing during operation.
l
Mist emerges from indoor unit.
l
Noisy during operations.
l
Remote control/display does not work.
l
The unit cannot operate.
l
Outdoor unit emits water/steam.
l
F566276_EN.indd
3
Control and Indicator
Panel (Signal receiving)
Air inlet
(rear)
(side)
Discharge air
Air outlet
ä This is a normal self protection control.
ä Caused by refrigerant flow inside.
ä Condensation effect due to cooling process.
ä Installation work could be slanted or intake grille didn't close properly.
ä Check whether batteries are correctly inserted or need replacement.
ä Check either circuit breaker is tripped, or timer is used correctly.
ä Condensation or evaporation happens at piping surface.
n About
OFF/ON operation button
• To turn off or turn on the air
conditioner.
• Operation mode, temperature, fan
speed and OFF/ON timer should be
set by remote control.
Auto OFF/ON Button
• To operate the unit if the
remote control is misplaced or
malfunctioning.
Action
Operation mode
Press once.
Automatic Operation
Press until
Cooling Operation
"beep" sound.
• To OFF, press again the Auto
OFF/ON button.
• To switch the remote control
signal receiving sound off or on.
1. Keep pressing the Auto
OFF/ON button for about 10
seconds until "beep-beep"
sound to switch off the signal
receiving sounds.
2. Repeat the above step if you
want to switch on the signal
receiving sounds.
AIR SWING
• Airflow direction only can be
adjusted manually.
• Vertical airflow direction control.
1. Pull the vane by the left and right
portion gently.
2. Don't use the uppermost and the
lowest vane to adjust.
3. Don't let the vanes downward
continuously for a long time,
otherwise condensation may be
caused around the discharge
vent.
• Horizontal airflow direction control.
To adjust horizontal airflow vanes
gently by holding the control handle
on the top left.
3
2008-12-16
10:08:46
Hide quick links:
Advertisement
Table of Contents
