Snooze Operation; Dimmer Operation - Sonic Alert SB200ss-v3 Operation Instructions

Alarm Patterns –
When the alarm is activated, alarm pattern of the buzzer / flashing display will be out of sync with the
vibrator. This means that when the buzzer / flashing display is ON, the vibrator will be OFF and while the
buzzer/ flashing display is OFF, the vibrator will be ON.
ALARM 1 - When Alarm 1 is activate, it will have 3 beeps for buzzer, then the vibrator. This pattern is
repeated until the alarm is stopped.
ALARM 2 - When Alarm 2 is activate, it will have 4 beeps for buzzer, then the vibrator. This pattern is
repeated until the alarm is stopped.
Adjusting the Alarm Duration Time
The default alarm duration time setting is 30 minutes; you may adjust the alarm duration between 1 minute
and 59 minutes as desired. To adjust the alarm duration:
• Press and hold the AL. SET button (5) for six seconds. The clock display will show the default alarm
duration as '30'. Release the AL SET button (5).
• Press the "SLOW" button (7) to adjust the alarm duration to the desired setting, from 1 minute to 59
minutes.
• When the display is showing the desired alarm duration time, it will return to the normal clock mode after
3 seconds. The new alarm duration time setting becomes the new default and remains in the memory
until you change it again.
Snooze Operation –
1. When the alarm turns on in the morning you may press the SNOOZE Button (9) to stop the alarm
temporarily. The alarm will shut
minutes, and then turn on again. The
turned off.
2. The SNOOZE function of Alarm 1 and Alarm 2 is independent of each other.
Adjusting the Snooze Time
The default snooze time setting is 9 minutes but you may adjust the snooze time between 1 minute and 30
minutes as desired. To adjust the snooze time:
• Press and hold the SNOOZE Button (9) for four seconds. The clock display will show the default snooze
time '9'. Release the snooze button
• Press the "SLOW" Button (7) to adjust the snooze time to the desired setting, from 1 minute to 30
minutes.
• When the display is showing the desired snooze time, after 3 seconds it will return to the normal clock
mode. The new snooze time setting becomes the new default and remains in the memory until you
change it again.
Shutting Off the Alarm –
Alarm can be shut off temporary for the day or permanently shut off.
1) When alarm goes off, press the "ALARM OFF" (4) button to turn off for the day and come back on at the
same time the next day, if alarm settings have not changed.
2) To shut the alarm off permanently, slide the "Alarm Mode Switch" (11) down to the OFF position. The
alarm will not come on until the "Alarm Mode Switch" (11) is set to "VIB/BUZZ", "VIB", or "BUZZ" position.
NOTE: The Alarm Off function of Alarm 1 and Alarm 2 is independent of each other.

Dimmer Operation

There is a 5-level brightness control for the LED display. Press the SNOOZE button (9) once to change the
display brightness. The brightness will cycle from 5-4-3-2-1-2-3-4-5 (from bright to dim then from dim to
bright).
*NOTE*: The dimmer function will not work, when the clock is in snooze mode.
Volume Control –
1) To adjust the volume, rotate VOLUME wheel (13) located on the lower right corner of the clock.
off for 9 minutes or for the predetermined time you select from 1-30
snooze operation may be repeated indefinitely until the alarm is