Insignia NS-RAD01-C Quick Setup Manual

PACKAGE CONTENTS

• Radio
• Earphone

FEATURES

Earphone jack
Tuning display bar
Tuning LED
Speaker

INSTALLING THE BATTERIES (NOT SUPPLIED)

1 Open the battery compartment door located at the
back of your radio.
2 Insert two AAA batteries into the battery
compartment. Make sure the + and - on the batteries
match the + and - inside the battery compartment
3 Replace the battery door.
BATTERY PRECAUTIONS
The radio will not work when the batteries are low. If
this occurs, replace the batteries.
• Danger of explosion if batteries are incorrectly replaced.
Replace only with the same or equivalent type.
• Use only the size and type of battery specified.
• Be sure to follow the correct polarity when installing
the batteries as indicated in the battery
compartment. A reversed battery may cause damage
to the device.
• Do not mix different types of batteries together
(e.g., Alkaline, Rechargeable, and Carbon-zinc) or old
batteries with fresh ones.
• If the radio is not to be used for a long period of time,
remove the batteries to prevent damage or injury
from possible battery leakage.
• Do not try to recharge a battery not intended to be
recharged; it can overheat and rupture. (Follow the
battery manufacturer's directions.)
• Exhausted batteries must be removed to prevent any
battery leakage.
Quick Setup Guide |
FM/AM Pocket Radio
• Wrist Strap
• Quick Setup Guide
NS-RAD01-C
Wrist strap hole
FM antenna
Wrist strap hole
Tuning dial
Volume switch
Band switch
Power ON/OFF
Battery door