Williams OVERTURE 2 Owner's Manual page 11

OVE RTU R E 2 D I G ITAL P IAN O
Front Panel Sound Assignments
Variation Bank
Grand
Original Voice
Bright
Variation Voice 1
Layered
Variation Voice 2
2. Press the Play and Track buttons together to
start recording. Once you start playing, the
display will show a small dot on the screen to
indicate that you are waiting to record. Then,
when you play the keyboard or press the Play
button, the display will show four small dots on
the screen to indicate that you are recording.
3. Press the Play and Track buttons together
again or press Play only to stop the recorder.
Then, press Play only to hear your song.
4. Repeat the steps above to record to the
other track.
Layer Mode
To layer two sounds, press the corresponding
voices simultaneously. Both voice LEDs will
light up to indicate that they are layers.
To layer two sounds from the second bank (third
bank), simply make sure the variation button
blue LED (red LED) is lit and then press the
corresponding voices simultaneously.
To layer sounds from different banks, do
the following:
• Press the button of the original voice and the
variation button simultaneously.
• Press the Variation button again to cycle
through to the desired bank of the layered
voice. The Variation button will blink to
indicate which bank is selected.
Note: The variation button LED will not blink if
the first bank is selected for the layered sound.
W ILLIAM S P IAN OS. CO M
EP 1 Perc
1 2 3
EP 2 Rock
1 2 3
EP 3 Church
1 2 3
Nylon Synth
4
Vibes Strings
4
Harpsichord Clavinet
4
• Select the desired voice for the layered sound.
Note: Once selected, the button of the layered
voice will blink to indicate that it is from a
different bank, while the voice button LED
remains lit. The Variation button LED will be lit or
unlit to indicate the bank of the original voice.
If one voice is selected from each bank, but they
share the same button, the instrument button
will blink. If two voices are in the same bank are
selected, the buttons should merely light.
To return to normal, single voice mode, press a
single Voice button.
To Change The Layer Volume Level
1. Press the Function button.
2. Turn the Value Dial to select the Layer
Volume Level edit menu, the display will
show "D .Volume".
3. Press the Function button again to enter
parameter edit menu. The numeric parameter
will blink to indicate the number is editable.
4. Turn the Value Dial to select the level of the
layer volume. (0-127)
D.Volume
Acoustic
5 6
Fingered
5 6
Syn BS 1
5 6
11