Advertisement
UV Lamp
Post-Filter
Item #US70015
Item #US50704
LW IIs
Thank you for your purchase of the EcoQuest Living Water Advanced Water
Treatment System. This system has been designed to provide you with years of
trouble-free operation and thousands of gallons of safer, great-tasting water with a
minimal amount of maintenance.
Product Registration Card
Please send in your EcoQuest product registration card to:
EcoQuest International, 310 T. Elmer Cox Drive, Greeneville, TN 37743.
Proper registration will serve as proof of purchase in the event your original receipt is
misplaced or lost.
If you have any questions regarding the installation and operation of your Living
Water or you require service, please contact you local authorized EcoQuest Business
Owner or call EcoQuest at 800.989.2299.
Use Restrictions
A minimum water pressure of 15 psi is required to operate the Living Water Unit (45
– 60 psi is recommended).
CAUTION: Do not drink water from the Living Water if the UV Lamp does not
activate or when there is no electricity.
In addition, the Living Water is not designed to process warm or hot water. Allow
only cold or ambient temperature to flow through the system.
Do not use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
System and installation must comply with local state regulations.
1
Pre-Filter
UV Lamp
Post-Filter
Item #US50705
Item #US70015
Item #US50704
LW IIIs
Installation of Countertop Models (CT)
Living Water IIsCT, and IIIsCT all come ready to install to most faucets. Installation
takes just a few minutes and requires a pair of pliers.
NOTE: The unit must be installed vertically (not horizontal)
WARNING: Remove protective packaging from inside the UV lamp housing before operation.
1. Remove the existing aerator and gasket from the faucet. If the threads on the hose
assembly do not match your faucets threads, use the included adapter or obtain one
from your local hardware store.
2. Thread the hose assembly onto the faucet.
3. Connect the shorter tubing of the diverter assembly to the inlet of the system by
simply pushing the metal tube into the lower fitting (located at the rear of the unit,
towards the bottom) until you hear a click.
4. Connect the longer tubing to the outlet of the system by pushing the metal tube into
the top fitting (located in the cap of the post-filter chamber) until you hear a click.
5. Place hoses as shown and plug the power supply into a nearby receptacle.
IMPORTANT: Do not plug your Living Water unit into an outlet that can be turned off with a
switch, such as an outlet for a garbage disposal.
5
1
4
3
2
2
Advertisement
