Panasonic Viera TC-P58VT25 Operating Instructions Manual page 24

Viewing 3D images on TV
Using the television menu controls, set so that 3D images are shown.
You can watch 3D images in the following cases: (As of February 2010)
• When a 3D image supporting Blu-ray Disc is played on a 3D image supporting player/recorder connected using a
HDMI cable to a 3D image supporting television.
• 3D image supported broadcast (program)
Press to exit from a
menu screen
Press to return
to the previous
screen
If the images cause discomfort, they can be adjusted with the following settings.
3D
settings
Auto: (Default) When the HDMI receives information
Side by side/Top and bottom:
Native: Displays the input signals as is on the screen.
When the HDMI receives information in which Full HD (Frame
Sequential Method) is detected, the image is automatically
displayed regardless of "3D input format" settings.
24
* If a signal received from an external device is different from the 3D setting of the TV, such as 2D signal when the TV is set to
3D mode, the images may not be displayed correctly.
Wearing the 3D Eyewear
Press and hold the power button on the 3D Eyewear for approximately 1 second.
(The Indicator lamp lights for approximately 2 seconds.)
Put on the 3D Eyewear.
If the 3D Eyewear slips out of place, hold it in place using the specialized band,
and adjust the length of the band. (p. 23)
If the 3D images are not displayed correctly or the images cause discomfort, the
images can be adjusted by following this procedure.
* The perceived three dimensional effects of the 3D Eyewear differ from person to person.
Display the VIERA TOOLS screen and select "3D"
Using Setup menu (p. 39)
Select the item and set
3D settings (see below)
3D settings
3D Eyewear
3D input format
Left / Right swap
Diagonal line filter
Safety precautions
After Use
Press and hold the power button on the 3D Eyewear for approximately 1 second.
(The Indicator lamp on the 3D Eyewear flashes 3 times, then the power switches off.)
After using the 3D Eyewear, store it in the case provided.
These settings are reset by switching inputs or selecting channel. (Settings will not be retained.)
3D Eyewear (On/Off)
On
3D Eyewear
Off: 3D images can be deactivated by turning "Off"
while viewing. (When 3D Eyewear is not worn)
3D input format
(Auto/Side by side/Top and bottom/Native)
3D input format Auto
in which 3D mode is detected, 3D images are
automatically displayed according to the signal.
(Switching may not occur depending on the signal.)
Allows you to set this setting to match the
image state.
Viewing 3D images
On
Auto
Swapped
Off
Left / Right swap (Normal/Swapped)
Left / Right swap
Change this to On when the phases are reversed
(when there is an unusual sense of depth).
Diagonal line filter (On/Off)
(Switch "Side by side" and "Top and bottom" types)
Diagonal line filter
On: Resolves discomfort caused by receiving a
Safety precautions
Displays message for viewing 3D images.
(Continued)
select
next
select
change
Swapped
Off
quincunx matrix signal.