Table of Contents
Advertisement
2. LED DISPLAY (Problems Shown on LED Indicator Combination)
Status of Indicator Light
Error
Cord
FAN
No.
00
(OFF)
01
(GREEN)
02
(GREEN)
03
(GREEN)
04
05
(GREEN)
06
(GREEN)
07
(GREEN)
08
(Orange)
09
(RED)
(Orange
10
flashing)
(RED
11
flashing)
(GREEN)
12
13
(GREEN)
NOTE
In each mode shown with this color, the projector returns to the standby mode after error indication for about
2 minutes.
TEMP
LAMP
(OFF)
(OFF)
(OFF)
(RED)
(RED
(OFF)
flashing)
(Orange
(OFF)
flashing)
(Orange)
(OFF)
(RED)
(OFF)
(Orange
(OFF)
flashing)
(OFF)
(OFF)
(OFF)
(OFF)
(OFF)
(OFF)
(OFF)
(OFF)
(OFF)
(Orange)
(Orange)
(GREEN)
Cause and Trouble
ON
Standby-power is not on
> There's a problem with the
power unit or system
(OFF)
microcomputer.
The lamp went out
(RED)
during use or the lamp
will not switch on
> The bulb has reached
the end of it's life.
(RED)
The power turns off
(RED)
>Trouble with the Lamp
cover
The power turns off or
does not come on
(RED)
> The inside is too hot, or
the projector has been
working in an area of
high temperature.
(RED)
Error Cord
05: Near the Lamp housing
06: Near the Intake fan
(RED)
07: Polarized filter
(RED)
The power turns off or
does not come on
(RED)
> Trouble with the cooling
fans.
Error Cord
(RED)
08: Intake fan
09: Lamp fan
10: Exaust fan
11: Intake fan (PJ202)
(RED)
The power turns off
(RED)
> System micon error.
Error Cord
12: Device Error
(RED)
13: Status Error
2-2
Solution
Check the power unit.
Check the connector.
Check the main PC board.
Change new lamp.
There may also be trouble in
ballast power supply.
The lamp cover is not properly
attached. Unplug the power
cord and reattach the lamp cover.
Place the projector correctly
so the intake and exhaust fan's
holes are not covered.
Turn the projector off, and
leave it for a while, and turn it
on again.
Clean the air filter.
Check the each cooling fan.
Wait for two minutes, and
turn on the power again.
Advertisement
Table of Contents
