Contents Features ..............2 Setup ..............17 Accessories ............2 Analogue TV Menu System ........21 Introduction ............. 2 Picture Menu............. 21 Preparation ............. 2 Sound Menu ............. 22 Safety Precautions ..........3 Feature Menu ........... 23 Power Source ............. 3 Install Menu ............
Features Accessories • Remote controlled colour LCD TV. • Fully integrated digital TV (DVB-T). INFO • HDMI connectors for digital video and audio. This SLEEP SCREEN SOURCE PRESETS connection is also designed to accept high defi nition signals. • USB input. Batteries: 2 X AAA RETURN MENU...
candles, are placed on top of the TV. Batteries should Safety Precautions not be exposed to excessive heat such as sunshine, Please read the following recommended safety fi re or the like. precautions carefully for your safety. Lightning Power Source In case of storm and lightning The TV set should be operated only from a 220-240 or when going on holiday,...
Disconnecting the Device The mains plug is used to disconnect TV set from the mains and therefore it must remain readily operable. Headphone Volume Excessive sound pressure from earphones and headphones can cause hearing loss. Installation To prevent injury, this device must be securely attached to the wall in accordance with the installation instructions when mounted to the wall (if the option is available).
Overview of the Remote Control Standby Image size INFO Sleep timer Numeric buttons Return / TXT Index SLEEP SCREEN SOURCE PRESETS Cursor up / TXT up page Cursor left Programme up Programme down Mono-Stereo / Dual I-II Swap Electronic programme guide (in DTV mode) RETURN MENU...
LCD TV and Operating Buttons Power On/Off Switch TV/AV button Programme Up/Down buttons Volume Up/Down buttons “ ” / “ ” Note: Press buttons at the same time to view main menu. Viewing the Connections- Back Connectors SCART socket inputs or outputs for external devices. Connect the SCART cable between SCART socket on TV and SCART socket on your external device (such as a decoder, a VCR or a DVD player).
Connect the audio cable between AUDIO INPUTS on the TV and audio outputs of your device to enable component audio. S/PDIF Out outputs digital audio signals of the currently watched source. Use an S/PDIF coaxial cable to transfer audio signals to a device that has S/PDIF input. You should also set SPDIF Out option in the Sound Menu as On.
Power Connection IMPORTANT : The TV set is designed to operate on 220-240V AC, 50 Hz. • After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the mains. • Plug the power cable to the mains socket outlet. Aerial Connection •...
Connecting the LCD TV to a PC Connecting to a DVD Player and external sources For displaying your computer’s screen image on your LCD TV, you can connect your computer to the If you want to connect a DVD player to your LCD TV set.
Using Side AV Connectors Connecting Other Equipment via Scart You can connect a range of optional equipment to your LCD TV. Possible connections are shown Most devices support SCART connection. You can below. Note that cables shown in the illustration are connect a;...
Switching the TV On/Off Basic Operations You can operate your TV using both the remote To Switch the TV On control and onset buttons. • Connect the power cord to the 220-240V AC, 50 Hz. Operation with the Buttons on the TV Then the standby LED lights up.
The Digital TV will automatically tune to the UHF or Initial Settings VHF(*) (* for EU countries) transmission channels, When the TV set is operated for the fi rst time, the searching for digital terrestrial TV broadcasts and Digital TV turns on fi rst. displaying the names of channels found.
General Operation Press the SOURCE button on the remote control and select DTV/USB to switch the TV set to digital terrestrial television broadcasting. Information Banner • Whenever you change channel, using the P- / P+ button or the numeric buttons, the TV displays the broadcast picture along with an information banner at the bottom of the screen (available only in DTV mode).
Channel List The operation method may differ depending on the contents of the digital teletext. Using the “ ” or “ ” button on the remote control, Follow the instructions displayed on digital teletext make sure that the first item, Channel List, is screen.
Note: If you enter the same programme number Now pressing “ ” or “ ” button moves to the previous/ of the channel that you want to move, “..channel next character. Pressing “ ” or “ ” button toggles services will be replaced.
Channel : “ ” or “ ” keys will navigate the user through the TV or Radio list. Date : Starting date is entered via the Left/Right or the numeric buttons. Start : Starting time is entered via the Left/Right or the numeric buttons.
• Some CAMs may require the following set up. Please set the CAM by entering the Digital TV menu, Conditional Access then pressing the OK button. (CAM set up menu is not displayed when it is not required.) • To see the viewing contract information: enter Digital TV;...
channels will not be located while in automatic search to “0000” initially. Enter PIN. If it is incorrect, “Wrong or manual search. Pin” OSD will be displayed. If it is correct, the Parental Control menu will be displayed: Use “ ” or “ ” button to select Scan Encrypted and then press “...
Page 20
When AUTO is selected, Current Time and Time Zone options will not be available to be set. If MANUAL option is selected as the Time Zone Setting, Time Zone can be altered: • By pressing “ ” or “ ” buttons select Time Zone. Use “...
Page 21
Use “ ” or “ ” buttons to highlight the menu item that will be adjusted and then press “ ” or “ ” button to set. Notes: • System Language determines the on-screen menu language. • Audio Language is used for selecting the soundtrack of a channels.
you will be asked whether or not to delete the settings. Analogue TV Menu System Selecting “Yes” by pressing OK button while the “Yes” Picture Menu is highlighted will delete the existing channel table. Then you will be asked to confi rm for deleting all channels and settings: By selecting Yes and pressing the OK button, the existing channel table will be deleted.
Press “ ” or “ ” button to select Film Mode . Equalizer Press “ ” or “ ” button to set this feature On or Off. Press “ ” or “ ” button to select Equalizer . Press “ ”...
Hence, if one of those buttons is pressed, Child Lock On will be displayed on the screen when the menu Automatic Volume Limiting (AVL) function adjusts the screen is not visible. sound to obtain fi xed output level between programmes Language (For instance, volume level of advertisements tend to be louder than programmes).
HDMI PC Full Mode (optional) Fine Tune If you want to view PC screen in HDMI mode by using Press “ ” or “ ” button to select Fine Tune. Press “ external connection, HDMI PC FULL MODE option ” or “ ” button to adjust the tuning. should be On to adjust the screen ratio correctly.
By moving the cursor in four directions you can reach Whenever you press the BLUE button, APS function 20 programmes in the same page. You can scroll the stops and Program Table appears on the screen. pages up or down by pressing the navigation buttons If you wait until the end of APS, Program Table will be to see all the programmes in TV mode (except for the displayed with the programmes found and located.
Autoposition Mute Function If you shift the picture horizontally or vertically to an Press “ ” button to disable sound. Mute indicator will unwanted position, use this item to put the picture be displayed in the upper side of the screen. into correct place automatically.
Teletext Use to view a normal picture (4:3 aspect ratio) as this Teletext system transmits information such as news, is its original size. sports and weather on your TV. Note that is the signal degrades, for example in poor/adverse weather conditions, some text errors may occur or the teletext mode may be aborted.
The picture quality may degrade when two peripherals Tips are connected to the TV at the same time. In such a Screen Care case, disconnect one of the peripherals. No Picture Clean the screen with a slightly damp, soft cloth. Do not use abrasive solvents as they may damage the Is the aerial connected properly? Are the plugs coating layer of the TV screen.
Appendix A: PC Input Typical Appendix B: AV and HDMI Signal Display Modes Compatibility (Input Signal Types) The display has a maximum resolution of 1600 X 1200 . The following table is an illustration of some of Supported Source Available Signals the typical video display modes.
Specifi cations TV BROADCASTING PAL/SECAM B/G D/K K’ I/I’ L/L’ RECEIVING CHANNELS VHF (BAND I/III) UHF (BAND U) HYPERBAND MHEG-5 ENGINE compliant with ISO/IEC 13522-5 UK engine Profi le 1 Object carousel support compliant with ISO/IEC 135818-6 and UK DTT profi le for UK Frequency range: 474-850 MHz for UK models 170-862 MHz for EU models...
Important Instruction For your own safety read following instruction carefully before attempting to connect this unit to the mains supply. MAINS (AC) OPERATION The wires in the mains lead are coloured in accordance with the following code : GREEN & FUSE YELLOW (Earth)
Page 33
Contents Features ............... 33 Stopping Play............ 43 •General Properties .......... 33 Rapid Advance (Rapid Reverse) ...... 43 About this Manual ..........33 ZOOM ............... 43 Safety Information ......... 33 Repeat .............. 43 Notes on Discs ............. 34 Display Function ..........43 On handling discs ..........
*** DVD-R/RW discs recorded by DVD-Video Features method can be played . Some DVD-R/RW • General Properties discs may be incompatible due to laser pick- up and disc design. • DVD / CD / CD-R / CD-RW / MP3 / JPEG / MPEG.
Notes on Discs How to Watch a DVD When placing a disc into the loader, labeled side On handling discs of the disc should be on the front: • To keep the disc clean, handle the disc by its edge. Do not touch the surface. •...
Using Digital Multimedia Connectors • Use SWAP button on the remote control to switch between USB and memory card. • You can connect USB/MC devices to your TV by using USB or MC input of the TV. This feature allows you to display/play fi les stored on a USB device or a MC card. •...
Overview of the Remote Control Standby Image size INFO Sleep timer Numeric buttons Return SLEEP SCREEN SOURCE PRESETS Cursor up Cursor left Programme up Programme down No function in DVD mode Audio-Language selection RETURN MENU Swap / DVD media selection No function in DVD mode Display time / DVD menu Clear...
> Highlight an item USB & MC Modes Playback by moving up or down. Switch to DVD source by using the SOURCE or > Play PLAY button on the remote control. > Pause You can connect both USB and MC sources to >...
Stopping Play The screen freezes. Press SKIP/ FRAME ( ) on the remote Press stop ( ) twice (only for videos). control. To stop the play permanently, press STOP ( ) The next frame of the movie is displayed. twice. When the STOP( ) button is pressed for the fi...
• If you wait fi ve seconds without pressing any title, the search box disappears and “ Input key to enter time, selecting scenes by time Invalid” message is displayed on screen. option is cancelled. • If you wait fi ve seconds without pressing any •...
number of times until “Subtitle Off” appears 2X” is displayed on the screen and the on the screen. picture is now larger. By pressing ZOOM key Changing Audio Soundtrack Language It is possible to change the audio language consecutively you can reach “ 3X”, “...
Stopping play Using a DVD Menu • To stop the play permanently, press STOP ( Some DVD discs have unique menu structures ) twice. When the STOP ( ) button is pressed called DVD menus. For example, DVDs for the fi rst time, a message “Press Play Key To programmed with complex contents provide Continue”...
• If “Single elapsed” is displayed, the elapsed Press ( ) on the remote control. time for the title which is being played will be You can increase or decrease the speed of the displayed. slow-motion play by pressing SEARCH/SLOW •...
Audio CD Track: To return to normal play; Elapsed or Remaining Time can be displayed Press ZOOM again. using DISPLAY key and can be changed using JPEG : INFO key. Press PLAY ( ) to start slide show.During PAUSE slideshow, you may change slide type (effect) by pressing ANGLE button.
TV Type Setup Menu TV Type is only available as ‘PAL’. The TV set Press DISPLAY key on the remote control when also supports NTSC signal; however, the signal the player is not in playback mode. will be converted to PAL when it appears on The setup menu-main page appears.
Disc does not play STEREO: Two channels stereo. PARENTAL (Parental Level) • No disc in the machine. Place a disc into the loader. • Disc incorrectly loaded. Ensure that the DVD disc is in the drawer with the label uppermost. •...
If nothing works Time Number If you have tried the above solutions and none This indicates the playtime, which has elapsed seem to work, try switching your TV-DVD off from the start of a disc or a title. It can be used to and on again.
Supported File Formats for USB & MC Modes File Format Remarks Media Extension Video Audio (Maximum resolution/Bit rate etc.) MPEG1 MPEG Layer 1/2/3 .mpg/ .dat/ MPEG2 MPEG2 .vob MPEG4 PCM/MP3 Movie MS ISO .avi PCM/MP3 Support SP and ASP MPEG4 Sample Rate: 8K ~ 48KHz MPEG 1/2 Music...
Disc Types Compatible with This Unit This player can play the following discs. English - 48 - [GB]_MB25_(02-DVD)_1900UK_PEUIDTV_NICKEL5_(WODIVX_WOVCD)_10065841.indd 48 [GB]_MB25_(02-DVD)_1900UK_PEUIDTV_NICKEL5_(WODIVX_WOVCD)_10065841.indd 48 20.10.2009 16:45:12 20.10.2009 16:45:12...