Irt Studio Usb Recording - Laney IRT-Studio IronHeart Instructions Manual

USB INTERFACE FOR PC, MAC & IPAD

IRT Studio USB Recording:

Connect your USB recording device (PC/MAC or iPad) via an appropriate USB cable.
Your amplifier will send two audio tracks to your recording device:
(1) On the Left channel the direct unaffected guitar signal.
TIP
(This can be used at a later date for "Re-Amping".)
(2) On the Right channel the amplified fully processed signal.
These can be split into separate tracks in various ways dependent on your software. The signal level of the left channel,
sent to the recording device, can be adjusted with the rear panel level control.
The signal level of the right channel is controlled by the IRT Studio volume controls.
The processed signal sent to the right channel can be emulated or left untreated via the emulation switch. (Note this
switch also affects the signal being sent via the XLR DI out).
TIP
(Alternatively record left & right as two separate tracks for maximum flexablity)
All this can be done without a speaker load connected.
However adding a speaker can in some cases give extra mechanical dynamics to the recorded sound.
20
Optional Speaker Load
IRT-Studio
Guitar Input
iPad/MAC/PC
Recording Device
USB