ZyXEL Communications NSA210 Quick Start Manual page 6

4. Slide in the hard disk into the tray until the hard disk
is fitted snugly inside the NSA210.
5. Attach the front panel to cover the hard disk tray.
Place the NSA210 on a flat surface with the bottom
panel facing up and tighten the screw.
If you want to use two hard drives and configure them as RAID volumes,
you should have: 1) a SATA hard disk installed inside the NSA210; and
2) an eSATA hard disk with its cable. It is also recommended to use the
same disk size and model for best performance. Refer to the User's
Guide for the steps to create volumes on your NSA210.
Connect the NSA210
1. Use the included Ethernet cable to connect the
LAN port on the rear of the NSA210 to a computer,
switch, or router on your network.
2. Connect one end of the power cord to the POWER
socket on the rear of the NSA210 and the other
end to the external power supply. Connect the
external power supply to a power outlet.
Use ONLY the included power adapter.
6