Adding to Z-Wave Network The SHD1111 can be associated in a group with up to 5 nodes. All devices associated with SHD1111 will be operated when the SHD1111 sends an alert after the door/window has been opened/closed.
Page 4
You can use the tamper switch at the back of the SHD1111 to include, exclude, associate with a Z-Wave Network, or reset. Tamper Switch Function Description LED Indication No node ID The Z-Wave Controller does On and off repeatedly at a 2-...
SHD1111 and the magnet respond to each other properly. Note: Do not press the tamper switch on the back of the SHD1111 at this stage. It is used for inclusion/exclusion to Z-Wave network. 2. Mount the back cover of the SHD1111 on the fixed part of the door/ window frame with the screws.
Page 6
1. The SHD1111 allows 10 minutes for adding to a Z-Wave network at inital power up. 2. The SHD1111 goes to sleep mode after 10 minutes if it is not added to a Z-Wave network. You can wake it up by pressing the tamper switch...
1.5 seconds to extend the awakened time to 10 minutes. 3. If the tamper switch is not pressed, the SHD1111 stays in testing mode. Detach the magnet from the SHD1111. The LED illuminates for 2 seconds to confirm that the SHD1111 and the magnet respond to each other properly.