Radio Reception - Sanyo FXR-303GB Operating Instructions Manual

Full auto reverse carfidelity receiver/ cassette player
Hide thumbs Also See for FXR-303GB:
Table of Contents

Advertisement

RADIO
RECEPTION
Band button (BAND) ... @
Each time the Band button is pressed the Radio frequency
band will be switched
in the following
sequence.
+ FM1 -+ FM2 -+AM
+ FM I....
Seek & Manual tuning
button
( FBI+, W-
)... @
Depressing
shortly (w+
) or (w–
) button, the radio frequency
on the digital
display will count up or down.
While depressing
(w+)
or (w-)
button half a second
more, will start SKIP
tuning towards higher or Iowerfrequency.
When you remove your finger from the
button
(w+),
(w-).
Automatic
tuning
starts automatically.
The tuning
pro-
cess will be stopped
when a strong signal
is received.
Local/Distant
Sensltlvity
(DX/LO)...
@
Press (DX/LO) to switch on and hold it for more than 2 seconds in order to receive
distant stations.
The (DX) indicator is shown.
To switch off, press (DX/LO) again
in order to receive nearby local stations only. The (DX) indicator goes out.
Presetting
Stations
(1
2
3
4
5
6)... @
First, tune into the desired station using the automatic
tuning system (SEEK) or
manually
(MANUAL, ~+
or ~–
). To memorize
a program,
press and hold
down the desired preset button for at least two seconds until the program number
in the display stops flashing.
In this way you can program 6 different stations or frequencies
in the 2 FM band,
as well as 6 AM stations.
Before recalling
a preset station, select the correct band using the band select
button (BAND).
The band you have selected
is indicated on the digital display.
Preset Scan (P.SCAN)...
@)
Press the Band button to select the desired band.
Then press and hold in the
Preset Scan (P. Scan) button until the channel number in the display flashes.
The
unit will automatically
scan the preset stations on the band selected,
stopping on
each one for approximately
5 seconds.
When a station that you wish to listen to
is heard, press the Preset Scan (P. Scan) button again. Preset Scan will automati-
cally stop and the unit will remain on the station.
Auto-Travel
Preset button
(ATP)...
@
. When the ATP button is pressed for 2 seconds or more, ATP is displayed
and
the radio automatically
memorizes
up to 6 stations beginning
with the one with
the strongest
signal.
. When the ATP button is pressed for less than 1.5 seconds, the first memorized
station is recalled.
To recall the stations one after another in the order they were
memorized,
repeatedly
press this button quickly.
N07E:
— If the signal levels of the broadcasting
stations are so weak that no stations can
be ATP memorized,
"(?00" is displayed
and no sound reproduced.
– 4-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents