SET‐UP INSTRUCTIONS
Your LOMAC machine is designed to give
you excellent performance and long life.
Reading this manual will help you get the
most from its many features.
ASSEMBLY:
In the box you will find: machine base (17)
(shipped with brushes installed), front flap
(9), storage tray (13), and three pieces to
make the handle (1, 2).
A. Remove the machine base (17) and
place it squarely on the storage tray.
Fig. 2‐1. To do this, raise the H piece (3)
upright until it locks. Lift the machine
with the flat painted bar indicated by
the arrow in Fig. 2‐1.
B. On flat surface lay out handle parts (1,
2). Fig. 2‐3. Connect handle parts by
pressing the release buttons while
pushing the parts together.
C. Place assembled handle on handle cone
assembly (5) indicated by the arrow in
Fig. 2‐4. Plastic cord holders (6) should
face toward rear of machine, the same
as large cord hook (10).
D. Be sure the snap lock knobs (4) are
locked in completely or the cones may
break and possibly cause damage to
the side housings (15,16). Fig. 2‐5.
2