Superior DRT3535 Series Installation And Operation Instructions Manual page 41

Innovative Hearth Products
Superior DRT/DRC3500 Series Direct-Vent Gas Fireplaces
TM
4. Install the three (3) AAA batteries in the transmitter battery bay, located on the base of the transmitter.
5. Push the ON button. The receiver will beep four (4) times to indicate that the transmitter's command has been
accepted and sets it to the particular code of that transmitter. The system is now initialized.
Temperature indicator display
1. With the system in the OFF position, press the THERMOSTAT key and the MODE key at the same time
(Figure 49).
2. Look at the LCD screen on the transmitter to verify that a C or F is visible to the right of the room temperature
display (Figure 50).
Turn ON the appliance
1. Press the ON/OFF key on the transmitter.
2. The transmitter display will show all active Icons on the screen. At the same time, the receiver will connect the
thermopile to the gas valve millivolt coil and the appliance main burner will turn on. A single beep from the
receiver will confirm reception of the command.
Turn OFF the appliance
1. Press the ON/OFF key on the transmitter.
2. The transmitter LCD display will only show the room temperature and icon. The receiver will disconnect the gas valve
and the appliance burner will turn OFF. A single beep from the receiver will confirm reception of the command.
Remote flame control
The system has six (6) flame levels. With the system ON, and the flame level at the maximum in the appliance, each
press of the DOWN ARROW key will reduce the flame height by one step until the flame is turned OFF.
The UP ARROW key will increase the flame height each time it is pressed. If the UP ARROW key is pressed while the
system is ON but the flame is OFF, the flame will come ON in the high position. A single beep will confirm reception
of the command.
Room thermostat—transmitter operation
The remote control can operate as a room thermostat.
1. Press the THERMOSTAT key.
2. The LCD display on the transmitter will change to show that the room temperature is ON and the set temperature
will be displayed.
3. To adjust the set temperature, press the UP or DOWN ARROW keys until the desired set temperature is displayed
on the LCD screen of the transmitter.
Smart thermostat—transmitter operation
The smart thermostat function adjusts the flame height in accordance to the difference between the set point
temperature and the actual room temperature. As the room temperature gets closer to the set point, the smart
function will modulate the flame down.
1. Press the THERMOSTAT key until the word SMART appears to the right of the temperature bulb graphic.
2. To adjust the set temperature, press the UP or DOWN ARROW keys until the desired temperature is displayed on
the LCD screen of the transmitter.
Fan speed control
This appliance is equipped with a hot air circulating fan. The speed of the fan is controlled by the remote, and can be
adjusted through six (6) speeds.
1. Press the MODE key to index to the fan control icon.
2. Press the UP/DOWN ARROW keys to turn ON, OFF, or adjust the fan speed. A single beep will confirm reception
of the command.
NOTE: The fan can be controlled only by the remote. Turning the fireplace OFF with the wall-mounted, three-
position slider switch will not turn OFF the fan. To turn OFF the fan, use the remote instead of or prior to shuting
OFF the fireplace at the wall. Fan speed will be indicated by either an OFF, Level Bar, or HI shown in the Set Point/
Temp/Level/State indicator area.
Key lock
This function will lock the keys to avoid unsupervised operation.
1. Press the MODE and UP keys at the same time.
2. To deactivate this function, press the MODE and UP keys at the same time.
Installation
900298-00, 10/2014
41