Table of Contents
Advertisement
Software Update
When the MUSICflow device is connected to your
home network, check whether the firmware version
is the latest on all speakers and the Music Flow
Player application.
Your MUSICflow device might require a more recent
firmware to be installed for optimal operation.
[Settings à Version Info]: you can check if your
speaker has the latest firmware.
How can I initialize speaker?
If you press down "
sounds once, the network related settings are
initialized. (For sound bar, "DISABLED" is displayed in
the display window.)
If you press down "
sounds twice, factory initialization is performed.
(For sound bar "RESET" is displayed in the display
window.)
Speaker is not connected.
1. 1. For a speaker that is already connected, make
sure the phone is connected to the same router
as the speaker. If not, connect to the same
router, also check the following.
1-1. Set Power off / on, and check the
connection.
1-2. If it is not solved by 1-1, close the
application and run again.
1-3. If it is not solved by 1-2, reset the Speaker
and reconnect. To reset, press and hold
the "ADD" button for 8 seconds until you
hear one beep.
1-4. If it is not solved by 1-3, delete the App
and reinstall, then try again.
2. If you change the location of the speaker that is
in use,
2-1. If the changed location is too far from the
home router, it may not be connected.
Place and use it at a location that is close
enough to router.
2-2. Connect the speaker with a LAN cable,
and for additionally installed speakers, if
they are not close enough to the speaker
connected with a LAN cable, additionally
install Bridge or another speaker in the
middle location between the speaker
connected with LAN cable and the
speaker with sound being disconnected.
LAS651M.BUSALLK_SIM_ENG_6763.indd 19
(Add)" button until Beep
(Add)" button until Beep
Troubleshooting
There are times that speaker
disappears from the application
1. If the speaker blinking lamp is not blinking, and
stays as white: Even after the speaker power
off and on, if the problem continues, in this
case you have to reset the speaker (To reset,
press and hold the "ADD" button for 8 seconds
until you hear one beep. ) then you need to
register again. Carry out speaker installation or
additional procedures.
2. If the speaker blinking lamp blinks white -
network signal is unstable. Wait for a while, or
move the speaker to another location closer to
another speaker or router.
3. Press menu key or menu at the top right side of
Home screen to end Music Flow Player app and
run again.
19
5
2015-02-25
3:19:31
Advertisement
Table of Contents
