Hardware Installation; Connect The Ethernet Cable - D-Link DCS-6004L User Manual

Section 2: Installation
Please refer to the steps below to assist you with hardware installation process for the camera.
Remove the Camera Housing
The camera housing needs to be separated from the camera base to expose
the screw used to adjust the viewing angle. Remove the camera housing from
the camera base by squeezing the housing release buttons on either side of the
camera. Once the housing is released, lift it up and off the camera base to expose
the Ethernet and power receptor.

Connect the Ethernet Cable

Connect the included Ethernet cable to the network cable connector located on
the panel at the rear of the DCS-6004L/ and attach it to the network.
Attach the External Power Supply
Attach the external power supply to the DC Power receptor located on the rear
panel of the DCS-6004L and connect it to your wall outlet or power strip.
Reattach the Camera Housing
Reattach the camera housing by lining up the housing so that the access port
on the housing matches the access port on the camera base. Firmly push down
until the camera housing snaps back onto the camera base.
D-Link DCS-6004L User Manual

Hardware Installation

11