Advertisement
T3 Temperature
If you have the T3 temperature sensor installed, it
appears after T2. This sensor can also be mounted
in a live well, on the hull to measure outside air
temperature, or just about any other location.
Engine Hour Meter
This shows the total number of hours the engine
has operated. It senses the engine operation from
the tachometer. The LDT-3003 must be turned on,
however to record engine time. The engine hour
meter cannot be reset. (Note: The engine must be
running in order to view the hour meter.)
Voltmeter
The voltmeter shows the current electrical system
voltage.
Setting the LDT-3003
The clock can be set to the correct time, alarms can be set to desired time
and/or temperature (for each temperature probe), and the temperature
displays can be set to °F or °C. The LDT-3003 has a "set" mode that
cycles through all of these settings, starting with the clock. To set any of
these features, simply press the SET key repeatedly until the desired
function appears that you wish to change, then press
the MODE key to change it.
Set Clock
The first time the unit is turned on, the clock ap-
pears. In this example, 12:00 is showing. To set the
clock, first press the SET key once. The colon be-
tween the 2 and first 0 begins flashing. Now press
the MODE key. The "12" begins flashing with the colon.
MODE
MODE
MODE
5
Advertisement
