Advertisement
Quick Links
Installation and Operation
The LDT-3003 combines a clock, hour meter, voltmeter, and up to three
temperature sensors in one housing. (Since the LDT-3003 is packed
with different options, you may not have all three temp sensors.) It
shows the temperature in either °F or °C, selectable by the user. This
unit fits in a standard 2 1/8" (54 mm) hole used by most marine equip-
ment manufacurers.
Mounting
The LDT-3003 mounts in any dash or flat panel that's at least 2 1/2" (64
mm) in diameter. To mount the unit, first make certain there is at least
3 3/4" (95 mm) from the front of the dash to any obstruction behind the
dash. Also, be sure there is room to route the power and sensor cables.
The maximum usable dash thichness is 1 1/8" (28.5 mm).
3 3/4" minimum
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
1 2 3 4 5 6 7
When you determine the location for the LDT-3003, drill a 2 1/8" (54
mm) hole in the dash. Slide the LDT-3003 through the hole from the
front of the dash. Align it so that it's straight, then tighten the two
screws with a phillips-head screwdriver.
Place the pushbuttons into the holes in the bezel and snap it on to the
LDT-3003. The unit is now ready for wiring.
LDT-3003
Instructions
DASH
TIGHTEN
THESE
SCREWS
1
Advertisement
Summary of Contents for Lowrance LDT-3003
- Page 1 Mounting The LDT-3003 mounts in any dash or flat panel that's at least 2 1/2" (64 mm) in diameter. To mount the unit, first make certain there is at least 3 3/4" (95 mm) from the front of the dash to any obstruction behind the dash.
- Page 2 DASH ORANGE YELLOW BLACK TO TACH SPEAKER DASH ORANGE YELLOW BLACK TO TACH SPEAKER WHITE BLUE GREEN 2-AMP TEMPERATURE FUSE SENSORS ACCESSORY SWITCH WHITE BLUE GREEN 2-AMP FUSE TEMPERATURE SENSORS BLACK ACCESSORY SWITCH 12-VOLT BATTERY BLACK LIGHT SWITCH 12-VOLT BATTERY...
- Page 3 Regardless of which wiring method you use, the LDT-3003 must be wired to a 2-amp fuse! Failure to fuse this product will void the warranty and could result in damage to the unit or your boat.
-
Page 4: Operation
OPERATION Modes The LDT-3003 has a clock,a clock alarm, up to three temperature dis- plays, an alarm for each temperature sensor, an engine hour meter, and a voltmeter. To switch between these modes, simply press the mode key. - Page 5 The clock can be set to the correct time, alarms can be set to desired time and/or temperature (for each temperature probe), and the temperature displays can be set to °F or °C. The LDT-3003 has a "set" mode that cycles through all of these settings, starting with the clock. To set any of...
- Page 6 MODE key. The clock alarm is now set. You can turn the clock alarm off by pressing the SET key until the clock alarm appears, then press the MODE key once, then press the SET key again.
- Page 7 MODE key to switch it to °C. Press the SET key twice to exit. The clock should now be showing on your screen. If it isn't, or if you get lost in any of these menus, simply turn the unit off and back on again.
- Page 8 Lowrance's UPS Return Service - U.S.A. Only Lowrance Electronics and United Parcel Service (UPS) are proud to offer all of our customers free shipping for all units sent to us for repair or service. If you have to send this unit to the factory, and you are in the continental United States, use the enclosed UPS shipping label for easy, free shipping to our factory customer service department.
-
Page 9: Accessory Ordering Information
KEEP THIS LABEL! YOU WILL NEED IT IF YOU EVER NEED TO RETURN YOUR UNIT TO THE FACTORY FOR REPAIR. Accessory Ordering Information To order accessories such as power cables or transducers, please con- tact: 1) Your local marine dealer. Most quality dealers that handle marine elec- tronic equipment should be able to assist you with these items. - Page 10 LOWRANCE ELECTRONICS FULL ONE-YEAR WARRANTY “We", “our”, or “us” refers to LOWRANCE ELECTRONICS, INC., the manufacturer of this product. “You” or “your” refers to the first person who purchases this product as a con- sumer item for personal, family, or household use. We warrant this product against defects or malfunctions in materials and workmanship, and against failure to conform to this product’s written specifications, all for one year (1) from the date of original purchase by you.
- Page 11 How to Obtain Service (Canadian Customers Only) We back your investment in quality products with quick, expert service and genuine Lowrance replacement parts. If you need service or repairs, contact the Lowrance Factory Customer Service Department at the toll-free number listed below. A techni- cian may be able to solve the problem and save you the inconvenience of returning your unit.
- Page 12 Your unit's serial number How to Obtain Service - U.S.A. Only We back your investment in quality products with quick, expert service and genuine Lowrance ® replacement parts. If you're in the United States and you have questions, please contact the Factory Customer Service Department using our toll-free number listed below.