Controller; Braking System; Release Brake (Freewheel); Armrests - Solax Mobility Mobie Owner's Manual

Controller

The controller which receives the signal from the control panel and transfers to motor and
brake is located in the rear section of the Mobie and must not be exposed to moisture at any
time as it may cause permanent damage. If exposed to heavy moisture, your Mobie must not
be used until it has been thoroughly dried out.

Braking System

The Mobie is equipped with electromagnetic regenerative brakes. This means that the Mobie
will stop when you let go of the throttle lever so that it goes back to the throttle default
position (center/stop position)

Release Brake (Freewheel)

The Mobie is equipped with "Release Brake" freewheel option. The release brake option
switch is located on the rear chassis. Enabling this feature will allow you to release the
brakes from the "lock" status so that you can push the Mobie in the event your battery runs
out of power. You also have the option to fold your Mobie and transport it like a hand-truck or
suitcase. Keep I mind that when the "release brake" option (freewheel) is enabled, the
control panel functions (speed throttle) will not be operational
WARNINGS: COMPONENTS & OPTIONS
NOTE: Do not use any parts or components unless they have been authorized by Solax.
Doing so will automatically void the manufacturer's warranty.

ARMRESTS

The Mobie armrests are optional and designed to flip up and fold so that they do not have to
be removed. You can adjust the armrest to fit your desired forearm placement. Make sure to
never lift this Mobie by its armrests.
Solax Mobie Owner's Manual V1.0
II. Safety
Page 14