Brother P-touch 2350 User Manual page 104

Error Message
BUFFER
FULL!
CHANGE
ADAPTOR!
CUTTER
ERROR!
INPUT
WHOLE CODE!
LENGTH
LIMIT!
100
Cause
• This message appears if you
try to enter a character, sym-
bol, barcode, space, return,
new block, or tab after 255
characters have already been
entered.
• This message appears if you
try to enter a character, sym-
bol, barcode, or space in a
layout field while using the
Auto format function after
255 characters have already
been entered.
• This message appears if a
high-voltage adaptor is
being used.
• This message appears if the
tape cutter is closed when
you try to print or feed the
tape.
• This message appears if the
set number of digits is not
entered in the barcode data.
• This message appears if the
text is longer than 3' 3 1/3" (1
meter) when you try to print.
• This message appears if the
Length function is used to set
a label length that is less than
1.6 inches (4.0 cm) or more
than 11.8 inches (30.0 cm).
• This message appears if the
Tab Length function is used
to set a tab length that is
more than 11.8 inches (30.0
cm).
Solution
• Delete some existing text so
that more text can be
entered.
• Edit the text so that it only
contains the preset number
of characters.
• Remove the high-voltage
adaptor and connect the
adaptor designed exclu-
sively for this machine.
• Turn the machine off, then on
again.
• Input the correct number of
digits or change the number
of digits set in the barcode
parameters.
• Shorten the text to less than
3' 3 1/3" (1 meter) before try-
ing to print.
• Set the label length between
1.6 inches (4.0 cm) and 11.8
inches (30.0 cm).
• Set the tab length so that it is
less than 11.8 inches (30.0
cm).