Philips 32PFL5625H User Manual page 24

Notes
During installation, leave [Settings]
•
unchanged unless your digital provider
provides you with specific values to
enter.
• When digital TV channels are found,
the list of installed channels may display
empty channel numbers. You can
rename, reorder or uninstall these
channels.
Access DVB-C or DVB-T channels
If you have installed both DVB-C and DVB-
T channels, you have to switch to the
respective network to watch channels on
that network.
1. While watching TV, press
2. Select [Setup] > [Advanced channel
settings] or [Advanced satellite settings] >
[Channel installation] > [Antenna or Cable
DVB] > [Air (terrestrial)] to access free-to-
air DVB-T channels; or [Cable] to access
DVB-C channels.
3. Press OK to confirm your choice.
4. Press to exit. The TV switches to the
selected network.
Manual reinstall
NonPu blish
This section describes how to search and
store analogue TV channels manually.
Step 1: Select your system
Note: Skip this step if your system settings
are correct.
1. While watching TV, press
2. Select [Setup] > [Advanced channel
settings] or [Advanced satellite settings] >
[Channel installation] > [Analogue: Manual
installation] > [System], then press OK.
3. In the list that appears, select the system
for your country or region, then press OK.
Step 2: Search and store new TV channels
1. In the [Analogue: Manual installation]
menu, select [Find channel], then press OK.
2. Press:
• The Navigation buttons or Numeric
buttons to manually enter the channel
frequency.
EN 24
.
.
The Navigation buttons to select
•
[Search]. Press OK to automatically
search for the next channel.
3. When the correct channel frequency is
entered, select [Done], then press OK.
4. Select [Store current channel] to store
the fine tuned channel using the current
channel number, or select [Store as new
channel] to store it as a new channel
number.
Fine tune digital channels
NonPu blish
If you receive digital TV broadcasts (DVB),
you can verify the quality and signal strength
of a channel.
If the reception is poor, you can, for
example, reposition your antenna or satellite
dish, to try to improve the reception. For
best results though, always contact a
professional installer.
1. Select the channel to test, then press
2. Select [Setup] > [Advanced channel
settings] or [Advanced satellite settings] >
[Channel installation] > [Digital: Reception
test] > [Search], then press OK.
The digital reception quality is shown for this
channel. If the reception is poor, reposition
your antenna or satellite dish and repeat the
procedure.
Notes
• You can enter a specific digital
frequency yourself.
Select the frequency, and change it with
the Navigation buttons. Select [Search]
to verify the frequency.
•
If you receive the channel with DVB-C,
the options [Symbol rate mode] and
[Symbol rate] are available.
In [Symbol rate mode], select
[Automatic] unless your cable provider
supplies you with a specific symbol rate
value. Enter this supplied value in
[Symbol rate] using the Numeric
buttons.
.