Change Language Settings; Change Other Settings - Philips 32PFL5625H User Manual

Fine-tune analogue channels
NonPu blish
If the reception of an analogue TV channel is
poor, try fine tuning the TV channel.
1. Press .
2. Select [Setup] > [Advanced TV settings]
or [Advanced satellite settings] > [Channel
installation] > [Manual installation] > [Fine
tune], then press OK.
3. Press or to fine tune the channel, then
select [Done] when complete.
4. Select [Store current channel] to store
the fine tuned channel using the current
channel number, or select [Store as new
channel] to store it as a new channel
number.

Change language settings

Audio, subtitle, teletext languages
NonPu blish
Digital TV channels may stream several
audio, subtitle and teletext languages with a
broadcast. Set preferred languages when
multiple languages are available.
1. Press .
2. Select [Setup] > [Advanced channel
settings] or [Advanced satellite settings] >
[Language] > [Primary audio] / [Primary
subtitles] / [Primary teletext].
3. Select a language from the list, then press
OK.
4. Press to exit.
Tip: Set a secondary language in the same
menu. You receive this language if the
primary language is unavailable.
Menu language
NonPu blish
1. While watching TV, press
2. Select [Setup] > [Advanced TV settings]
> [Preferences] > [Menu language].
3. Select a menu language from the list, then
press OK.
.

Change other settings

Green eco settings
NonPu blish
1. While watching TV, press the green
button.
2. Select one of the following settings, then
press OK:
[Energy saving]: Applies a combination
•
of picture settings to reduce energy
consumption.
[Mute screen]: Turns off the TV
•
display. 'Muting' the screen saves
energy if you just want to listen to
audio from the TV.
[Light sensor]: To save energy, the
•
built-in ambient light sensor lowers the
brightness of the TV screen when the
surrounding light darkens.
Audio lip sync
NonPu blish
Turn on digital audio lipsync to automatically
sync the image on your TV to audio from a
connected Home Theatre System.
1. While watching TV, press
2. Select [Setup] > [Advanced TV settings]
> [Preferences] > [Audio Out delay] >
[On], then press OK.
TV clock
NonPu blish
You can display a clock on the TV screen.
The clock displays the current time using
time data received from your TV service
operator.
Display the TV clock
1. When watching TV, press .
2. Select [Clock], then press OK. The clock
displays on the TV screen.
Note: To disable the clock, repeat the
procedure.
Change the clock mode
By default, the clock mode is set to
[Automatic], syncing the TV clock to
Coordinated Universal Time (UTC). If your
TV cannot receive UTC transmissions, set
the clock mode to [Manual]. [Country
dependent] applies UTC and gives you the
option of setting [Daylight saving].
.
EN 25